Replacing front discs

[TMAQ]

muy bien. good job :thumbs:

Tino

[sailorbaz]

Looks well mate, good write up.

[glendog74]

el buta any reason for the whole thread to be copied :whistle:

None.

[s.mac]

nice job, great pics :thumbs:

el buta any reason for the whole thread to be copied :whistle:

[escarolo]

perfect :thumbs: is 356, 380 ?

356 mm, more than enough

[el buta]

perfect :thumbs: is 356, 380 ?

[escarolo]

Spanish solutions !:hahaha: ... una mass cerveza it is then ! :beer:

:hahaha:

[DuncanR]

And for the visit, it would be better an afternoon beer :beer: but I will be in Bucharest on Friday :banghead:

Spanish solutions !:hahaha: ... una mass cerveza it is then ! :beer:

[escarolo]

great write up escarolo ..... just one thing missing .... a tea break mate ! we are English after all !!:thumbs:

My stepson and daughter are moving to Madrid on Friday, she works for Sleazyjet, will look you up when i next visit mate !! ....we can do afternoon tea !:hahaha:

I did the break with Red Bull :hahaha:

And for the visit, it would be better an afternoon beer :beer: but I will be in Bucharest on Friday :banghead:

Best Regards

[DuncanR]

great write up escarolo ..... just one thing missing .... a tea break mate ! we are English after all !!:thumbs:

My stepson and daughter are moving to Madrid on Friday, she works for Sleazyjet, will look you up when i next visit mate !! ....we can do afternoon tea !:hahaha:

[escarolo]

Good write up - thanks for taking the time to do this :thumbs:

One question: do the replacement nuts/bolts require threadlocking with Loctite or similar?

I think is not necessary

Best Regards

[glendog74]

I never have with no issues Rob, but make sure you dont over tighten them. :thumbs:

Thanks Shane :beer:

[shane@mbtech]

Good write up - thanks for taking the time to do this :thumbs:

One question: do the replacement nuts/bolts require threadlocking with Loctite or similar?

I never have with no issues Rob, but make sure you dont over tighten them. :thumbs:

[glendog74]

Good write up - thanks for taking the time to do this :thumbs:

One question: do the replacement nuts/bolts require threadlocking with Loctite or similar?

[shane@mbtech]

I was taught not to spray the hub where the bell mounts as it can cause slight run out issues.

Good write/picture up none the less.

Them AP's look like they have certainly been used in anger:thumbs: