Announcement
Collapse
No announcement yet.
Search Result
Collapse
500 results in 0.1546 seconds.
Keywords
Members
Tags
-
oil drain plug is M12x1.5 maybe they used the same pitch here?...
-
+1
swapping out a slave is much easier than dropping the tranny to redo the clutch....
Leave a comment:
-
My concern with the 10k bendpak is even though the curb weight of the truck is 8000lbs the front axle of the truck is 5500lbs so that would technically...
Leave a comment:
-
Lift Recommendations?
So I am finally taking the plunge and getting a 2 post lift for the garage. Our M3 is lowered quite a bit... Curious what folks out there like/dislike...
- Likes 1
-
When replacing the whole master cylinder I have had better success with vacuum bleeding from the caliper than pressure bleeding from the reservoir. Vacuum...
- Likes 1
Leave a comment:
-
One thing to check along with the codes is to make sure there is no obstruction in the travel of the throttle bodies. Sometimes folks use hose clamps...
Leave a comment:
-
California Car Covers is who i've seen. But they are like $800. I only need it for a couple months, not spending that kind of money....
Leave a comment:
-
Which car cover for car with giant wang and splitter?
Does anyone have recommendations for a car cover that will fit the M3 with a giant wing and front splitter? Need to park the car outside during some garage...
-
Ouch. I guess I would find a used pallet and put it up on uShip or similar site. Be prepared to get alot of phone calls though. Going direct to fedex...
Leave a comment:
-
Might be cheaper to box each one up individually and ship two ground packages.
Leave a comment:
-
This might be an issue. I think the purpose of that last step is to measure the clutch bite point with the engine turning and usually only takes a fraction...
Leave a comment:
Leave a comment: