Announcement
Collapse
No announcement yet.
Search Result
Collapse
438 results in 0.1007 seconds.
Keywords
Members
Tags
-
Love this. You doing the flap?
-
Peel and stick zotek closed cell foam would be another highly effective way to reduce temps without having to change your laminate. Pretty sure It’s...Last edited by Bry5on; 04-13-2024, 07:58 AM.
- Likes 1
Leave a comment:
-
Just a thought. Rust (inside the vanes) is a pretty good thermal insulator. Maybe we could experiment with passivating rotor internal surfaces with citric...
Leave a comment:
-
Same issue here with my 2022 Karb box. I added foam in these spots:...
- Likes 1
Leave a comment:
-
Oh man, that would be a cool project - I'd love to have a Wideband O2 sensor in-the-loop conversion for the e46 chassis. But no, not in scope
...
- Likes 3
Leave a comment:
-
Turn your wheel full lock and take a photo of your tire and perch clearance, ideally with a scale in the photo. Then go with the highest offset you can...
Leave a comment:
-
RIA009 18x9.5 et40 should juust fit perfectly up front with a 255/40/18 or 265/35/18 if you don’t have a coil over perch getting in the way. That’s...
Leave a comment:
-
If you're local, we can definitely arrange something. I've got to figure out the value of this and how I might go about that, especially if I were to...
Leave a comment:
-
More than could be an option, it IS an option!
I'm a couple more tweaks in and I've dialed both cold start idle and warm idle pretty well...
- Likes 1
Leave a comment:
-
Well, the Mullet Tune is an absolute resounding success! This morning, I removed the stock airbox, added some extra foam where the filter didn't seal...Last edited by Bry5on; 04-06-2024, 05:39 PM.
- Likes 4
Leave a comment:
-
Ok, so I've been driving my car around with the stock airbox (and now the no NVH exhaust) and I love how responsive the throttle is at low revs and how...Last edited by Bry5on; 04-05-2024, 07:59 PM.
- Likes 7
Leave a comment:
-
Read on from here: https://nam3forum.com/forums/forum/m...087#post246087...
- Likes 1
Leave a comment:
-
Awesome. No real tricks, other than being super cautious to not turn the steering wheel while you're installing. You can re-clock the plastic piece if...
- Likes 1
Leave a comment:
-
Stock Section 2 - Bay Area
Looking for a stock M3 section 2 here in the Bay Area. With or without the heat shield under the half shaft CV. If you've got one or got a lead on one,...
Leave a comment: