CSLReg Display Plates

[karbonkid]

Mine are the same, has to be down to the printers as the flag is different (not faded) and on the file used to make it, the letters are centered.

I have just had a chat with the printers and they told me all their settings for it to be centered when going to print were correct and are not sure why they would appear slightly off centre. TBH I didn't notice as its marginal, otherwise I would have queried it at the time.

For what they are initially going to be used for on track I think you will even find it hard to read the plate from a distance, let alone get a chance to get the tape measure out on it. Well.... not strictly true when knowing how slow some of you drive.

Joking aside, if this is an issue PM me and I will get another set made up for you.

I have been informed from the printers that all plates that are ordered from today onwards will be revised, but will have to be manually adjusted as the plate is centered on their systems.

[7.77]

[shimmy]

i think youll find the have put the gap between CSL and Register in the middle!:thumbs:

[karbonkid]

UPDATE - Plates Exchange

Further to our discussion of the CSLReg Display Plates being off centre, the Printers have agreed to recall all the plates and replace with the new revised version 'FOC'!

For all who wish to have theirs changed please return back to me and you will be replaced with the new set. I will PM everyone with the return address & make sure you have all seen this.

[karbonkid]

Had a few ask best ways to secure the plate. I have no drill holes, mine are taped. When drilled they often let water in & look messy too IMO.

I use this stuff, works perfect, tested to 170mph, leaves no mess when taking off, Lightweight!... and costs under half the price of a Pint! :thumbs:

[Sailorbaz]

Good shout.

and costs under half the price of a Pint! :thumbs:

So, just less than half a pint then... for those Half Pint drinking fags! :hahaha:

[Sailorbaz]

Morning KK,

I'm home on Thursday now, so if you get a chance today or tomorrow to mail me my 'newly revised plates' that would be great.
Thanks again for all your effort,
Baz

[karbonkid]

Morning KK,

I'm home on Thursday now, so if you get a chance today or tomorrow to mail me my 'newly revised plates' that would be great.
Thanks again for all your effort,
Baz

Evening Sir. I will try and get someone to send yours & another out tomorrow as Im currently away till Thurs. Either way they'll be yours for the weekend.

[Dan_csl]

Had a few ask best ways to secure the plate. I have no drill holes, mine are taped. When drilled they often let water in & look messy too IMO.

I use this stuff, works perfect, tested to 170mph, leaves no mess when taking off, Lightweight!... and costs under half the price of a Pint! :thumbs:

Only tested to 170mph Alex!? I need it to be tested to destruction if I'm going to buy on recommendation, can you pop back out and please try harder!? :hahaha:

[Sailorbaz]

Evening Sir. I will try and get someone to send yours & another out tomorrow as Im currently away till Thurs. Either way they'll be yours for the weekend.

No worries at all mate, look forward to receiving them :thumbs: