Miltek too loud!!!!!

[shimmy]

I bet you have the old back box by milltek

Driving Bealos I have been ver surprised how nice sounding, non droning and not loud the Milltek is tbh

There was an old droney Milltek and I think a newer better version

[shane@mbtech]

I bet you have the old back box by milltek

Driving Bealos I have been ver surprised how nice sounding, non droning and not loud the Milltek is tbh

There was an old droney Milltek and I think a newer better version

Thats it, put the mileage on bealos you whiley old fox you:hahaha:

[glendog74]

I have a Miltek system running with 100cell cats and im getting pissed off with how loud it is. Im starting feel like a boy racer :banghead:

I had this setup fitted within weeks of buying my CSL a few years back - BIG mistake! I removed the 100 cell cats within just a few months as the noise was just ridiculous. That helped but ultimately i ended up removing the whole system as it got on my tits in the end!

IMHO, the best system with a little added 'extra' is standard cats, standard centre section, and Supersprint Race Lightweight back box. I ran this setup for some time and it didn't drone even half as much as the Miltek did and retains the distinctive CSL 'rasp'.

I now have the Supersprint centre section fitted too and will shortly be having the Supersprint manifold fitted too :smt055

[shimmy]

Which one did you have Rob



Or this

[Sailorbaz]

See Shimmy, I've had two of the 2nd Gen Millteks. The 1st one wasn't too bad, droned but not as bad as the brand new one I got last year under warranty. It's shocking bad and I'm looking forward to chopping it for my Supersprint which arrived safely last week!

I was surprised to hear Bealo's is quite non-drony... good though I suppose.

[glendog74]

Which one did you have Rob

I had the newer version 2 ^^^

Would never put a Miltek on any car after my experience...

[shimmy]

I was always of the same opinion but I am totally gobsmacked by Bealos.

I'll have to take it out and get it warm and try again:smokin::beer:

[outnumbered]

I briefly had the "new and allegedly non-droney Version 2" Milltek on my previous E46 M3..... but it still droned like a bastard at 2500rpm and provoked all sorts of rattles and buzzes from interior trim as a result, so it wasn't on there for long.

Sounded great otherwise, but just got on your nerves around town.

[Dan_csl]

I now have the Supersprint centre section fitted too and will shortly be having the Supersprint manifold fitted too :smt055

Is there much gain to be had from these Rob or are you fitting it for another reason, weight for example?