Announcement

**plumber vic** · 03-13-2013, 03:41 AM

Any good for back of seats. ???

**digi** · 03-13-2013, 03:44 AM

dunno, but dame this is inexpensive and easy to restore to original.

http://www.youtube.com/watch?v=rNY9Dx617N8&feature=player_embedded

http://www.youtube.com/watch?v=vvkq-qyY9aY&NR=1&feature=endscreen

:drool::drool:

**Pooky** · 03-13-2013, 04:27 AM

Think there's been a thread about plsstidip on seats, someone even found the right colour

**0836whimper** · 03-13-2013, 07:31 AM

I've plastidipped the seat backs to help protect them.
Still look good, although NZ_M3 reckons it might over time affect the paint underneath. I've not seen that so far.

Main issue is the grippy surface, it's harder to slide over (or run a cloth over) and I haven't done the rear centre console yet for that reason.

Swapping driver and passenger seat upholstery - NA M3 Forums

https://nam3forum.com/forums/forum/csl-register/general/csl-technical-area/518729-swapping-driver-and-passenger-seat-upholstery

After 100k km there was a small area on the drivers seat that started to look, well, not fully brand new. Just a hint of wear so far. You know the spot where you wear it a little bit extra each time you get in and out of the car. The passenger seat was as brand new so i decided to swap the alcantara, seat and back cushions

Also, clear plastidip on the sill plates doesn't work.

**digi** · 03-13-2013, 08:31 AM

used matt paint? Looks nice. Provides much needed protection. :smokin:

Announcement

Spray on plastic

Spray on plastic

Comment

Comment

Comment

Comment

Comment