Originally posted by 911-32
View Post
Announcement
Collapse
No announcement yet.
Garage Floor
Collapse
X
-
Yes, it works very well. I have done painted garage floors 2 ways recently. On my own garage it had a very rough cast concrete floor, which I levelled using large buckets of levelling compound (about 30 bags for a double garage) and then painted that using cheap grey garage floor paint. This looks good, but lifts a little with wet car tyres. On my friends garage, we went the other way. It was old concrete with minor broken sections and we used an epoxy levelling compound as there was much less depth to fill in than mine. This worked very well and is proving to be bullet proof tough. In hindsight, I wish I had used epoxy over my levelling compound due to the hardness of the finish. It does cost a lot more than paint though.Originally posted by Ariel View PostLoving the chess board tile look!
Has anyone had any experience of the coloured resin floor screed?
Cheers
I realise this is replying to an old thread, but just sharing the knowledge.
Leave a comment:
-
Great job love the wall art, got to get my garage ready in France to take the car next year, hoping to get a ramp in their too :thumbs:
Leave a comment:
-
It's perfect - the only thing I have done since then is add a little wall art
.






If money was no object, I would have changed the up and over doors for some sectional (insulated) roller ones, but that would have wiped out the budget completely
. Obviously being twice the size and height would have been nice (allowing me to have a lift), but that is for the lottery win :hahaha:.
Leave a comment:
-
That looks awesome Mike. How are they holding up 4 months on? Would you do anything different?Originally posted by Mike R View PostIs as good as finished - updated pictures here:
https://www.flickr.com/photos/163924...h/27559683328/
Leave a comment:
-
Nice job Mike - thanks for sharing. Interface at the front looks like it should hold up.
Leave a comment:
-
Yes so a large trim piece to cover the last/first tile egde...
Would be useful to update this thread in a few months perhaps to see how well it lasts? In case there's any movement or cracking...?
Cheers
Leave a comment:
-
The roof is flat concrete (well, slightly slanted for drainage), completely sealed, with garden on top. It's like a concrete bunker built into a hill. Ill post a photo when I get a chance.Originally posted by Mike R View PostIs probably condensation - is your ceiling open or boarded up?
Only ventilation is a small slit in the garage door itself. I think ill have to install some sort of Ventilation shaft, towards the back in the corners, as that's where the condensation occurs.
There is indeed old paint on the floors and I think a layer or screed - will have to remove that too.
Loving the wheel rack on the wall - great idea.
Leave a comment:
-
If you have painted your garage floor, you do need to remove the paint prior to fitting the tiles though, so something else to be aware of:
Leave a comment:
-
Originally posted by JBird View PostAlso keen to see how it turns out as will have do do the same in the not too distant future.
Was first going to go with click tiles, but then realised that in summer water puddles have been appearing on the floor, so I need something that seals the floor well so the water stays on top and can dry out.
The water is bit of a mystery actually, have been scratching my head over it. The garage is built into a hill and as such remains quite cool all year round. I think in summer when it is hot outside and I open the door, the warm air condensates on the cooler walls / floor. Garage is bone dry in winter otherwise, so I am pretty sure walls floor are all water tight (36cm thick concrete). Would like to solve this but don't really know how, other than heating the garage. (guessing a humidifier would just be a bandaid solution). Grateful for any advice here if anyone has had a similar situation.
Is probably condensation - is your ceiling open or boarded up?
I fitted ten of these roof vents in mine:
Leave a comment:


Leave a comment: