Carbon Air flow cover

[billyboysm3]

Good work!!!!

[alexk]

It looks good Mark !

BTW, what is wrong with your ram-air hole grille.
It should be sitting at 45 degrees.

[CraigMillwardCroft]

Nice work Mark, that is a real clean engine bay, how do you get into all those tiny places :whistle:

[Bounce]

Looking good Mark:thumbs:

[Neil M]

Looking good but what happened to the proposed CSL Graphic, forgot or thought better of it? :whistle: :notworthy:

[CraigMillwardCroft]

Looking good but what happened to the proposed CSL Graphic, forgot or thought better of it? :whistle: :notworthy:

He got is little finger stuck making the hole in his latest project :whistle:

[Mark CSL]

Looking good but what happened to the proposed CSL Graphic, forgot or thought better of it? :whistle: :notworthy:

The one i had just did not look cool .

Doing some more dash trims and fuse box lid i will post up some pictures when done :thumbs:

I put a set of dash trims on ebay and they sold within an hour of listing them
so 2 more sets in production :smokin:

[Mark CSL]

It looks good Mark !

BTW, what is wrong with your ram-air hole grille.
It should be sitting at 45 degrees.

Sorry Alex did not spot that i will get it sorted m8 :hahaha:

Nice work Mark, that is a real clean engine bay, how do you get into all those tiny places :whistle:

Hover and small brush

[SachaR]

Looking good Mark :supz: , just out of interest, did you use polyester or epoxy resin?

[shimmy]

Truely remarkable Mark, such dexterity from a northern man with fat fingers :-D

[Mark CSL]

Looking good Mark :supz: , just out of interest, did you use polyester or epoxy resin?

I used the epoxy resin i have other resin that sets in 1 hour but has a green tint to the carbon when you build up the coats.

The epoxy i use takes around 3 hours to get tacky and 24 hours to get hard enough to sand.

Truely remarkable Mark, such dexterity from a northern man with fat fingers :-D

Thanks Shimmy :thumbs: I Think ?

[SachaR]

Epoxy is also much harder and resistant than polyester. I was just asking as I have used both for other applications and lately a lot of epoxy to make actual parts.

Will have to give it a try on some parts....

[Mark CSL]

I am just playing around with it its fun :supz:

[NZ_M3]

Your intake grill on the bumper is crooked Mark ...

Otherwise :notworthy: