Clutch wear??

[Radders]

can't find any information on the CSL clutch wear. anyone had one replaced? how long do they tend to last and what tell tales signs indicate that it could be on its way out?

it is just like any other semi automatic like the fez and start slipping etc?

[DazBlackCSL]

Yeah just had mine done at 45k , and its the second one under warranty , did not notice the second one ... but seems too lag when hard pushing , like an old fashioned satellite delay !! :hahaha: ... first one was really bad ... .. now its pin sharp whatever im doing :-D

[Radders]

Yeah just had mine done at 45k , and its the second one under warranty , did not notice the second one ... but seems too lag when hard pushing , like an old fashioned satellite delay !! :hahaha: ... first one was really bad ... .. now its pin sharp whatever im doing :-D

ummm mine seems to lag when pushing hard, especially into 2nd gear.

how can you get a clutch done under warranty?? thats a first for warranty to cover clutches?

[DazBlackCSL]

its covered if you have a full warranty ... the first one I said it needed it , the second one they suggested it !!

Sytner are good tho , in my experience as long as you dont take the piss and get silly things changed all the time ..like door trims etc ...

If its slipping , simple , book it in and tell them , should be no issue :thumbs:

[AlexGTT]

Yeah, book it in if you have warranty. Had mine changed at 36,000 miles. It was slurring/slipping on change up. Clutch was not worn out after inspection. They said a compensating component was faulty, so changed that, clutch and flywheel all under warranty.

I use Cotswold Cheltenham and have had good service so far.

[Jaw_F430]

I will be asking to get mine done soon as it feels quite bad. Only 23K on the clock though


When I am drving it and take the rpm to about 6k,change up and I seem to get this slurr before it seems to grip but doesn't feel as bad if I take it to the redline (if that makes sense)

[SMD]

All CSL SMG will slip if you change at 6k and dont lift off the throttle!

[bryce]

As above. Its normal.

[rs32]

I noticed this too. what is the reason for the slip at certain revs ?

[Jaw_F430]

All CSL SMG will slip if you change at 6k and dont lift off the throttle!

Really? Hope mine is worse than most and a new clutch does stop it a bit.

[Radders]

thanks for all the comments, will get it back out on the road and test it again. could of been the traction control cutting in i guess as it was damp/wet when it happened

[dave1]

i get slur if i change at 4k or 5k but not at full tilt which i find strange

[SpineOnABap]

I noticed this too. what is the reason for the slip at certain revs ?

No idea. Talked about it for five years. Chances are it's initially a software error, but BMW never provided a solution so we're stuck with. Maybe the software not taking into account 'normal usage wear' properly. Then of course if you keep allowed it to slip then you're compounding the problem.
That's the best 'guess' anyway.

Bottom line is it's pretty pants how we never got a permy solution :banghead:

[SMD]

Yes sure is! I always lift a little on gear changes but when going out for a blast sport on S6 and foot to the floor and never lift and its fine! :-D

[AlexGTT]

The trick is NOT to lift on changes. If you do, the self learn element of the software gets used to relaxed changes and slurring gets worse.

I use the box in S1 to warm up and keep and even throttle on changes up the box. When the engine oil is up to temp I move to the desired mode for my drive (usually S6 :wink: ). Then, either full throttle shifts or, at mid rev up-shifts just keep an even throttle. Definately no lifting. The change on mine stays very sharp with this treatment. :thumbs: