AP Racing Discs

[Deezer-D]

Couple of pics of the discs. Do you think there's any life left in these or should I bite the bullet and replace them?













I only have one of these bolts, how many should I have?



Cheers
D

[Deezer-D]

Got the BBK today. Will post some pics of the discs tomorrow and measure the thickness. I think theres a bit of life left in them yet but would like some second opinions. I only do about 4K miles a year so may not need to shell out another 700 odd notes for discs and pads just yet.
Cheers
D

[shimmy]

www.asperformance.com

Mention the forum. Should come in just under 500. PF disc Kit is approx 560 inc vat and delivery I believe, not too bad either.:thumbsoes a good price on the rs29s as well.

Alyn doesnt normally do Pagid stuff even though he poccasionaly sells them, but i have bought PF discs and pads from him before and he is very good.

[daniel]

www.asperformance.com

Mention the forum. Should come in just under 500. PF disc Kit is approx 560 inc vat and delivery I believe, not too bad either.:thumbsoes a good price on the rs29s as well.

[Deezer-D]

Cheers shimmy

[shimmy]

It was Steve who replied to my email. There's only £7 per disc price difference between Questmead and Simpsons.
Anyone know what size Pagid pads I need?
Cheers
D

Both Simpsons and Questmead will.

For most Pagids you'll want E8018 shape code.

[Deezer-D]

Best I had was 500 with bolts and delivery.

Who was that from?

[Deezer-D]

It was Steve who replied to my email. There's only £7 per disc price difference between Questmead and Simpsons.
Anyone know what size Pagid pads I need?
Cheers
D

[daniel]

Best I had was 500 with bolts and delivery.

[shimmy]

Thanks for the advice guys, just e-mailed Questmead for prices. I went through Auto Performance Products site as Questmead seem to be trade only. Should I have gone directly to Questmead?
Cheers
D

RIng Questmead direct should get thru to Allan or Steve.

[Deezer-D]

Guys, anyone have the Pagid part no. handy please?
Thanks

[Deezer-D]

Thanks for the advice guys, just e-mailed Questmead for prices. I went through Auto Performance Products site as Questmead seem to be trade only. Should I have gone directly to Questmead?
Cheers
D

[_Nathan_]

<beavis and butthead> he said bell end :hahaha: </beavis and butthead>

[The Gorilla]

Hi,

Once bedded in properly to get the best from them
take them through a full heat
cycle and get them really, really hot
almost to the point of glowing, and then just
let them sit, and cool down.

They should have a blue 'heat' colouring
at the belles end etc. after this.

This can cause Pad residue to run down
which when cool you need to clean off.

Regards,

The Gorilla.

[jibm]

new bolts all round, low Nm torque wrench (14Nm), loads of WD40, a well fitting spanner and some patience,

Fit new pads onto new discs, but keep the old ones for use after the disc is worn (you can even them up with some sand paper later on)

BED THEM IN PROPERLY AS INSTRUCTIONS and dont use them on track or to bed in with DS2500

+1 and don't use DS2500 on track, as they leave deposits on your lovely new disc's and fook them :bigcry: