Geniune 18" E46 M3 Alloys

[billyboysm3]

As above will these fit on the csl with AP's.

Theres loads about going cheap that I could put decent tyres on for TD use to save ruining my nearly new eagle F1's.

Or try and get a couple of more rears to put on the front and run square set up?

Billy

[breeze]

It think it depends on which AP caliper you have.

One will fit the 18" factory wheels with no problems, the other will require a spacer.

[shimmy]

It think it depends on which AP caliper you have.

One will fit the 18" factory wheels with no problems, the other will require a spacer.

Rears are ok,

cP5575 fit under 18s and cp5555 need spacers on front

[billyboysm3]

Ive bought Matts ones, all 9j rears and fit fine, very close but all good.

[mattCSLnut]

Rears are ok,

cP5575 fit under 18s and cp5555 need spacers on front

I'm guessing Billy must have the CP5575 APs as the 18" 9J went on a treat :smokin:

[billyboysm3]

picture

[shimmy]

The cp5555 would hit the spokes Billy and not the outside rim. AP basically cut soe off the width to get the callipers under the 18 inch rims

[billyboysm3]

The cp5555 would hit the spokes Billy and not the outside rim. AP basically cut soe off the width to get the callipers under the 18 inch rims

I get ya.

Billy

[_Nathan_]

The cp5555 would hit the spokes Billy and not the outside rim. AP basically cut soe off the width to get the callipers under the 18 inch rims

Probably not with a rear wheel on the front though?

[northernjim]

Probably not with a rear wheel on the front though?

+1:clown:

[shimmy]

Probably not with a rear wheel on the front though?

good point :hahaha:

and offset is smaller so sticks out further on top of that :banghead: