CSL Engine Rattle - Help

[nigelonich]

Can anyone tell me the torque settings for the flywheel bolts and for the four bolts that hold the front pulley on? I think its 115nm for the flywhel bolts but no idea what to use for the front pulley.
Cheers

[giraffe]

60NM then 50`, 50`For vibration damper ( 4 bolts ) . 120NM flywheel bolts

[nigelonich]

Thanks. We fittted the flywheel back on last night and got the pulley on. A satisfying moment when it made it to the bellhousing for a couple of amatuers like us!:thumbs:

[nigelonich]

Going great with the rebuild but>

Any idea what goes in this plug which is on the fule rail? We cant seem to find anything to plug into it and wondered if it was spare?

http://i50.photobucket.com/albums/f301/nigelonich/csl01.jpg

Thanks in advance.

[Mark CSL]

There is a wire and plug come up from below and it plugs in to this
Not sure where it goes with out removing the airbox

[nigelonich]

Thanks. Ill keep looking. Ive not fitted the airbox yet so it must be in there somewhere.

[nigelonich]

Found it hiding down behind the back of the head. Thanks.

[nigelonich]

Result

Well, after a few long nights in the garage the moment came to turn the key. Ill be honest and say it didnt start at first and that was due to the earth strap not being connected to the block from the chassis. Easy fix and quickly found. No fault codes and started first time. The new engine sounds a million times better than the last one. Claimed to have only 18,000 miles on it and you can see its still very shiny in the clip.

Thanks for the help/advice from you all.

http://www.youtube.com/watch?v=Kef99R0oWFU

:thumbs: