Optimum ride height?

[Mike RT4]

Is there such a thing?

I think my car sits too low (H&R coilovers), so want to set it to what-ever is considered the optimum height that achieves the best geometry (as in the least amount of bump steer in compression etc).

[shane@mbtech]

I have it in my little black book at home. If no one answers ill tell you tonight.

[shane@mbtech]

Measured floor to arch

Try 645mm front, 640mm rear.

[need4speed]

Simpson Motorsport usual set up CSL with a ride height of 645mm Front and 640mm Rear (Wheel arch to ground - Level surface). At least that's what they set with Intrax coilovers.

[need4speed]

Measured floor to arch

Try 645mm front, 640mm rear.

Sorry Shane you beat me to it!! :-D

[Mike RT4]

Muchos grassy arse :supz:!

[Mike RT4]

Measured floor to arch

Try 645mm front, 640mm rear.

While you're feeling generous, what are the recommended geometry settings?

[alexk]

OEM ride height is 665mm front an 650mm rear.

[s.mac]

Geo depends on your preference.
Some have two settings and a compromise between road and track.
Some set to Oem.

I would need to dig the sheets outs.

Guesstimate without looking
Anything from -1.5 / -3.5 camber front
Toe to suit
Rear -.5 to maybe -2
Toe to suit

[s.mac]

If you don't mind me saying you have to lose that rear window thing

[northernjim]

If you don't mind me saying you have to lose that focking awful rear window thing

just say it how it is steve:beer:




settings are a personal thing depending on what you want and how you drive as I am sure you know mike:beer:

[s.mac]

:whistle:

[Neil M]

It's the first time I seen the rear window spoiler off a Touring used on a CSL, whatever floats your boat:thumbs: Got to go if 'Cred' is to be restored :supz:

[Mike RT4]

You'll have to blame Rich for the roof spoiler - its some sort of Schnitzer part, which will be removed at some point.

With regards to the geo, it's currently on factory settings after a recent KDS alignment done a few months ago.

I have Turner Motorsport rear bush limiter kit and some Simpson Motorsport top mounts to go on, so I'm after some suitable track settings for Cups .

[CraigMillwardCroft]

It's the first time I seen the rear window spoiler off a Touring used on a CSL, whatever floats your boat:thumbs: Got to go if 'Cred' is to be restored :supz:

Sure it could be sold on cutters as a CSL part :whistle: