WRXEATR DIY: Replacing Your Steering Column Guibo

[m3f_BleedsBlue]

You're supposed to remove the jack pad and put the stand where the pad was. W/e people do it all sorts of different ways and few have died.

[m3f_WRXEATR]

Rubber between the jack, and the frame of my car = ok with me.

[m3f_BlueAngel M3]

One of the best write ups I've seen so far.

[m3f_WRXEATR]

One of the best write ups I've seen so far.

[m3f_BlueAngel M3]

Under ''What you will need'' you mention a wobble. Not exactly sure what that is.

[m3f_WRXEATR]

Under ''What you will need'' you mention a wobble. Not exactly sure what that is.

[m3f_BlueAngel M3]

Thanks! I already have a set of those!

[m3f_PurduinaM3]

Those are swivels, these are wobbles:

[m3f_BlueAngel M3]

I call them extensions.



I have all sizes in 1/4, 3/8 and 1/2.

[m3f_BlueAngel M3]

Bobby, are u gonna be there tomorrow?

[m3f_shaeff]

I call them extensions.



I have all sizes in 1/4, 3/8 and 1/2.

No, these are extensions:





Pay careful attention to where the socket connects. The ones Bobby posted are cut differently, thus allowing the socket to literally wobble on the end, whereas the ones I posted are square cut, and the socket stays tight on the end.

[m3f_BlueAngel M3]

Shaef, thanks!

[m3f_BlueAngel M3]

So what do I need the wobble or the swivel? Sizes?

[m3f_das borgen]

just get them both from Harbor freight for the price of peanuts

Have the satisfaction of fattening up your tool arsenal BlueAngel_M3

[m3f_BlueAngel M3]

just get them both from Harbor freight for the price of peanuts

Have the satisfaction of fattening up your tool arsenal BlueAngel_M3

I'm working on it.