okay, about 3 months ago i snapped the front diff bolt driving a bit too hard, relized the bushing was bad, pressed a new one in got a new bolt and fixed the problem. . . or so i thought. last night it snapped again, had to walk 7 miles back home=no bueno. has any one had this problem? i think the problem is the design being there is only one diff mount in the front that takes all the load. so im hoping someone here knows of a kit or something that could help reinforce it. thanks
-
-
AA sells a bolt on kit for about $265 and Maximum Psi sells a weld-on kit for about $35 (the welding can be done on the car and might take 30 minutes). I think a set of three heavier duty bushings alone might be sufficient, like those from AKG. There is a thread on this subject that was active within the last 30 days. -
So you went to the effort to swap the front bushing, and didn't do the rear "ear" bushings while you were there? Hummm..
I've got the AA brace, and I know Mike's brace kit works as well. (I got the AA brace used, for a lot less than they want ...lol)Comment
Comment