Clutch change... few questions

[m3f_m pwrd 3]

I am getting ready to put a new clutch in my car this week and I have a few questions.



Its a 97 M3.



What are the torque settings for the bolts on the transmission?



What are the torque settings for the pressure plate?



If anyone has the bently manual would you please scan the torque guide for me?



Thanks

[m3f_Norlin]

Flywheel to crankshaft (use new bolts) 105Nm / 77ft-lb

Pressure plate to flywheel:

M8 8.8 grade 24Nm / 18ft-lb

M8 10.9 grade 34Nm / 25ft-lb

Transmission drain/fill plug 50Nm / 37ft-lb

Back-up light switch to transmission 20Nm / 15ft-lb

Transmission output flange to output shaft:

Stage I 190Nm / 140 ft-lb

Stage II (after loosening) 120Nm / 89ft-lb

Guide sleeve to transmission 10 Nm / 89in-lb

Reinforcing cross brace to chassis (M10) 42Nm / 31ft-lb

Rubber mount to transmission or bracket nut (M8) 21Nm / 16ft-lb

Slave cylinder to transmission 22Nm / 16ft-lb

Transmission to engine (Torx-head):

M8 22Nm / 16ft-lb

M10 43Nm / 32ft-lb

M12 72Nm / 53ft-lb

[m3f_m pwrd 3]

Thanks a lot!!