Announcement

Collapse
No announcement yet.

Clock light out or not working?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Clock light out or not working?

    There's no clock display and I searched and read couple threads about changing the bulb behind the OBC. CAR: 97 M3/4





    AFTER I GOT THE OBC OUT, I PUT ONE OF THE WORKING BULBS INTO THE CLOCK SLOT BUT STILL NO LIGHT AND DIGITS. TRY ANOTHER WORKING BULB STILL NO LIGHT. THE OTHER THREE LIGHT BULBS ON THE OBC WORKING FINE.



    DOES ANYONE KNOW WHAT ELECTRICAL PROBLEM I'M HAVING? IT'S NOT THE LIGHT BULB.



    ANY ADVICE OR INFO WOULD BE APPRECIATED, THANKS.

    #2
    i would get an electrical tester and start tracing the problem from that slot back.. thats about the only advice i have.. maybe it got severed some where behind ur HU or something.. just a thought..

    Comment


      #3
      Thanks, I'll try that.

      Comment


        #4
        try the following fuses #31 5amps fuse #23 5amps and #45 7.5 amps. but the again the obc runs on same wires for lighting. you probably need a bc.

        Comment


          #5
          If the light is out, you can still barely see the actual display. If the actual display is out, your bc is probably cooked and you would need a new one.

          Comment


            #6
            wats the bc? i have the same problem

            If the light is out, you can still barely see the actual display. If the actual display is out, your bc is probably cooked and you would need a new one.

            Comment


              #7
              i need a new obc,i post a pic here a while back and sirius state the lcd is shot,the pixel dont show a true reading as of the clock does the same too.

              Comment


                #8
                wats the bc? i have the same problem



                BC = on Board Computer.



                AKA: OBC.



                BMW likes to call it the BC for some reason or another.

                Comment


                  #9
                  I found the source, No ground to the clock slot! Wired ground to the clock slot and it works now.



                  Thanks for all the info and advices.



                  Before this I was looking into ebay for OBC; chechk this out:



                  http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=7949148201&rd=1&sspage name=STRK%3AMEWA%3AIT



                  http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=7950220364&rd=1&sspage name=STRK%3AMEWA%3AIT

                  Comment


                    #10
                    [QUOTE=odejavue]I found the source, No ground to the clock slot! Wired ground to the clock slot and it works now.



                    I also have the same clock light problem. The clock works fine, you just have to angle the display to see the lcd digits.



                    But I opened up the OBC and noticed the ground side of the light goes to the middle lead of a transister. I figure this must be connected up to some ambient light auto-dimmer or something. If I ground it, it will be full bright all the time.



                    Anyone know of this clock light problem, and what to do to fix it, other than shorting it out?

                    Comment


                      #11
                      the whole bc altogether from the dealerships cost me $2200 with stock new radio, climate control and the rest of the sh!t

                      good luck

                      Comment


                        #12
                        the whole bc altogether from the dealerships cost me $2200 with stock new radio, climate control and the rest of the sh!t

                        good luck



                        I know the OBC is fine. I've got another one that I know works, and that has the same problem. So what I think is that one of the electrical leads that indicates the level of ambient light OR the headlight status.



                        If the headlight is on, then the clock light should be affected by the instrument dimmer rotary switch. If the headlight is off, the clock should be full bright.

                        Comment


                          #13
                          ebay.. get a new one.

                          Comment


                            #14
                            ebay.. get a new one.



                            A new what? M3?



                            I know the OBC is good.

                            Comment


                              #15
                              i need a new obc,i post a pic here a while back and sirius state the lcd is shot,the pixel dont show a true reading as of the clock does the same too.



                              I have a spare 18 button. Got it expecting to convert from 11 button but conversion is PITA!



                              $80 plus ship. PM if interested

                              Comment

                              Working...
                              X