The issue is the timing chain overhang is sealed against the head gasket. So if you remove the timing cover you could introduce a leak from the timing cover/block/head joint. I'd guess that is more of an issue with an old head gasket. If there ever was a situation where you could get away with not removing the head...it's this one.
VANOS seems to be the biggest culprit at the moment. Thats an easy enough job and can probably squeeze this in after work today. I'm not confident this is the case, I'll try and explain my reasoning as best as I can.
1.
OP, when you installed the VANOS unit, did you push the splined gears attached to the VANOS pistons all the way into the VANOS unit before installing the VANOS unit on to the cylinder head?
- It looks like the post you referenced had this one step past where it needed to be. From what I can remember, I had to do a slight CCW rotation before inserting the splines. So the teeth should be correct, it doesnt hurt to check at this point
3. If there was piston to valve contact, wouldnt this be visible on a borescope? My only experience of contact is on a 7500 RPM explosion which is likely a lot more violent and this left significant signs of damage.
4. The engine has had countless turns at this point. The timing is locked, correct or incorrect if something made contact it would have done it early I don't see how it would wait until now to sieze.
Going back through all of this, the only thing that has changed from the last time I hand cranked until now is the flywheel, clutch, and trans. I'm leaning towards some sort of obstruction inside of the trans area, maybe a flywheel bolt backed out etc. Either way, pulling the vanos is a HELL of a lot less time consuming than dropping the trans or oil pan. Best case scenario we learn that the cams move freely and the problem is related to crank/trans area.

small world
Leave a comment: