Cheapest place to get Nogaro's?

[Obioban]

I’d say PPs are slightly better on track, the Nogaros are significantly better on street.

[ridebikes]

I'm considering these over Pole Positions I've had previously. Are you still enjoying them?

I recently put these in my car and love them. It's snug, well bolstered, but not hard to get in it out of. Highly recommend! Though if you have PPs, it might be a bit of a lateral move 🤷♂️

[Mpower04]

I'm considering these over Pole Positions I've had previously. Are you still enjoying them?

[repoman89]

I'll be interested to see how hard the install on the M3 will be and would be quite interested in any info, I want seat heats and manual sliders. I currently have power seats/seat heats.
I haven't even looked into the M3 install but after putting these in the 996 I just know at some point the M3 needs a set as well.

Did you get the "Street" or "Circuit"? I am think I would get the Circuits as I like the look plus the obvious track benefits if I ever get into that, very doughtful in this vehicle though.

I was thinking about making a write up and posting here on harness creation. It looks like it’s going to be easy but I stared at my stock harness, realoem and eBay listings for a while to figure it out. Waiting for some pin contacts to come in before proceeding.

I got the circuit, no reason not to imo. I barely drive this car on the street and am just getting into track. Probably will be at least 50:50 track:street usage for me going forward.

[Cubieman]

Can’t wait to install mine. Stock seats are out, just need to build up wiring harnesses for electric seat slider power and for the heater pads. This way I can sell my stock seats in a non-butchered state. I couldn’t figure out how to access the second upper heater plug anyway to unplug it.

I'll be interested to see how hard the install on the M3 will be and would be quite interested in any info, I want seat heats and manual sliders. I currently have power seats/seat heats.
I haven't even looked into the M3 install but after putting these in the 996 I just know at some point the M3 needs a set as well.

Did you get the "Street" or "Circuit"? I am think I would get the Circuits as I like the look plus the obvious track benefits if I ever get into that, very doughtful in this vehicle though.

[repoman89]

Can’t wait to install mine. Stock seats are out, just need to build up wiring harnesses for electric seat slider power and for the heater pads. This way I can sell my stock seats in a non-butchered state. I couldn’t figure out how to access the second upper heater plug anyway to unplug it.

[Cubieman]

man those look so good. I may need to order a set sooner! HMS had a lot in stock?

Yea, they were ready to ship, I so badly want a set for the M3, great weight savings, badass seats.

[Tonggi]

man those look so good. I may need to order a set sooner! HMS had a lot in stock?

[r4dr]

Wow, that was quick. Those seats look great.

[Cubieman]

Wow I really like these seats, quite similar to the factory GT3 seats as you can see. Would love a set in the M3, these are a great mix between street/full race seats. They also look extremely good for the price, $1230 a side.

[Tonggi]

I have them comming from HMS, it was $3080 shipped to NE. I purchased:
- 2 circuit seats (black vinyl outer/dinamica inner)
- 2 BK mounts for a 996

Now...I have no idea what I will be dealing with in terms of airbag/occupancy sensors etc. and don't have any Porsche software, looking into getting Durametric or PIWIS if I need to code a module and/or clear dash lights. I sure hope it doesn't come to that but it may from my preliminary reading on the subject. Rennlist here I come.

I got mine shipped to FL ground. 2 circuits same as your set up and 2 BK mounts for an E46 M3. I have the Airbag module already and I think i need to buy some parts for the auto slider which shouldnt be too much i dont think.

[Cubieman]

$2900 shipped for Cobra Nogaros from HMS isn't bad at all! Does anyone know if they ever have any sales during Memorial day weekend or any of the holidays?

I have them comming from HMS, it was $3080 shipped to NE. I purchased:
- 2 circuit seats (black vinyl outer/dinamica inner)
- 2 BK mounts for a 996

Now...I have no idea what I will be dealing with in terms of airbag/occupancy sensors etc. and don't have any Porsche software, looking into getting Durametric or PIWIS if I need to code a module and/or clear dash lights. I sure hope it doesn't come to that but it may from my preliminary reading on the subject. Rennlist here I come.

[Tonggi]

$2900 shipped for Cobra Nogaros from HMS isn't bad at all! Does anyone know if they ever have any sales during Memorial day weekend or any of the holidays?

[bassel_sy]

https://nam3forum.com/forums/forum/m...ck-bucket-seat

thank you

[Obioban]

I was checkin demontweeks site, and under the options i see a black/red do you know what this is referring to ? Also , i cant remember but there was a thread about your seats, i want to mimic your front seat set up.

https://nam3forum.com/forums/forum/main-forum/e46-2001-2006/415-review-cobra-nogaro-seats-uniquely-street-friendly-fixed-back-bucket-seat