If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Yes, they were very cracked before. They didn't get drilled for the cracks, had a buddy who tig'd it and it is cracking again on some of those welds.
I want to drill the cracks. Weld the cracks up. Than spotweld the reinforcement plate to the tower
At this point, you really should at least stitch weld the plate underneath with a MIG then hammer the metal flat against the plate finish with a couple of rosette welds on the top side. If you just tack weld the plate you're going to be in the same spot as you are now or maybe worse.
Comment