
Announcement
Collapse
No announcement yet.
Obioban's 2005 IR/IR Coupe
Collapse
X
-
-
I have a new obsession, and it is this tire.
If there's a company I'm a fanboy of it's Michelin, and these sound like the perfect track tire for my wants. Optimized for long life, fine to drive to/from the track, and onboard temp/pressure monitoring as well as suggestions for pressure changes for better lap times-- in an app I can run on the Avin, on track.
Fuck yes.
Ordering.
Leave a comment:
-
Yeah, I need to go through and replace them. Host went down.
- Likes 1
Leave a comment:
-
Do the pictures on the first page just not load for anyone else? They aren't showing on my computer or my phone
Leave a comment:
-
Originally posted by Obioban View Post
The material I used didn’t hold up to the heat (they semi melted), and I don’t have access to a large enough 3D printer at my née job… so my hand was forced.
I kept the mounting brackets for future use, should I get access to one again…
Build is looking sick though, kudos.
Leave a comment:
-
Originally posted by bryce2113 View Post
I'm curious to hear what made you move away from your custom 3D printed brake ducts. I used your design to print a pair over the winter. How do you like the Hard motorsport kit, specifically the slim low profile ducting component they now have?
I kept the mounting brackets for future use, should I get access to one again…
- Likes 1
Leave a comment:
-
Originally posted by Obioban View PostGood progress recently (later than I hoped, but... big undertakings this winter)...
Installed the final tube of the brake ducting, and confirm it fits without issue in all positions:
I'm curious to hear what made you move away from your custom 3D printed brake ducts. I used your design to print a pair over the winter. How do you like the Hard motorsport kit, specifically the slim low profile ducting component they now have?Last edited by bryce2113; 06-09-2021, 07:08 PM.
Leave a comment:
Leave a comment: