E46 M3 CSL MAP Conversion Kit

[COVID-19]

E46 M3 CSL MAP Conversion (new never used) Same scaling as OEM CSL MAP.
-Sensor - Adapter - Sensor Connector - DME Connector - Bolt -

*FROM NOW I WILL ONLY HAVE THEM IN METAL*

*Will need 2 hose clamps (3/8-7/8) 1 butt connector for DME signal wire (black wire) to Sensor connector (unless you plan to solder the wire)

$120 shipped(CONUS) plus PP fees or gifted

Can sell the adapter by itself just PM me.
Add $4 for USPS priority shipping in CONUS.

1vvTsEX.jpg





IMG_8233.jpg


1st graph - Engine off then start, idle then rev and back to idle

2nd graph - Engine at idle
FF7F62F0-21A7-46AE-9626-922FD5AA22D9.jpeg C1C5682B-14A9-4589-9F56-B9FDDD0AB7A8.jpeg

[COVID-19]

Bump

[COVID-19]

Bump

[COVID-19]

Bump

[Cubieman]

These are awesome, use this if plan to run a map sensor.
I have the Kassel adapter as well but there a few reasons that this style is the way to go, one of those is the greatly reduced cost!

[COVID-19]

These are awesome, use this if plan to run a map sensor.
I have the Kassel adapter as well but there a few reasons that this style is the way to go, one of those is the greatly reduced cost!

Thanks man!

[IanK]

Shout out to Erick for making this product, as mentioned above there are several reasons I preferred having the map sensor in this location and his adapter is a far less janky way to get it mounted nicely in there, thanks again!

49912953696_b9fa83e51a_z.jpg

[COVID-19]

Due to big delays from the supplier on the metal piece (even with expedited shipping). Decided to get them 3D printed. Slightly modify them for a shorter neck, bigger inner diameter where the hose connects while maintaining the same outer diameter for a good fit and a slightly bigger face were the sensor sits. Was also logging several readings everywhere I went for the pass few days and readings were a a bit more steady compared to the metal piece. (Nothing out of the ordinary but definitely steadier readings)

Will have pictures tomorrow of the new adapter.

(First one is engine at idle)
(Second one is engine off, started car then a rev)


IDLE.JPG

image_8743.jpg

[COVID-19]

Adapters will now be in Carbon fiber nylon. Still show identical readings to the plastic. (Steadier than metal)
Still have about 3 adapters in metal if anyone is interested in those.

[ATB88]

Review from a happy customer: this kit makes MAP conversion unbelievably easy. I had never wired anything in my life and the t-taps made it absolutely painless and simple. All you need to buy beyond this kit is a wire stripper/crimper tool and a butt connector for the DME pin wire.

[KeFF0r]

Hello mate like your idea

do u have anymore of the metal adaptors?

what’s the cost to ship to UK?

Thanks

FAZ

[eforty6_m3]

Hey, are you still selling these? I'm interested in buying your kit. Thanks!

[COVID-19]

Hey, are you still selling these? I'm interested in buying your kit. Thanks!

Yes. I still do. Just pm me.