Cutting valve through exhaust port

[x Spades x]

Hey Everyone,

I have a bend in two valves, right at the base of the valve guide opening. I can clearly see in looking into the port. Is there a cutting that can go directly in to cut? I found mini cutting wheels that may fit, but don't know of a driver.

Thanks in advance!

[eacmen]

Not sure why you created a new thread.

Mini cutting wheels are typically used with die grinders and dremels.


Sent from my iPhone using Tapatalk

[x Spades x]

Didnt know if there specialists out there, that have done this specifically.

I dont know if the have horizontal dremels, etc.

[Icecream]

Just a thought, since it sounds like this is giving you more trouble than it's worth, take it to a machine shop. They will charge hardly anything and can install the new valves/guides without damaging anything else.