While drying the driver door jamb on my car after a recent wash, I noticed I was missing some hardware. Trying to figure out what I need via RealOEM, but can't seem to narrow it down correctly so turning to you lovely people in hopes you can help.
First off, the bolt that the top arrow points to from this photo of the passenger side, door open, looking towards the front fender:
Same bolt/location can also seen at the 9:03 mark in this video:
. Is this the right 10mm bolt? Looks similar enough.
Second, the clip/pin that the bottom arrow points to is also missing on my driver side. Wondering if this might be the culprit?
Any help/insight is greatly appreciated. Can't figure out which RealOEM diagram specifically details these 2 items.
Thanks and cheers!
First off, the bolt that the top arrow points to from this photo of the passenger side, door open, looking towards the front fender:
Same bolt/location can also seen at the 9:03 mark in this video:
Second, the clip/pin that the bottom arrow points to is also missing on my driver side. Wondering if this might be the culprit?
Any help/insight is greatly appreciated. Can't figure out which RealOEM diagram specifically details these 2 items.
Thanks and cheers!
Comment