No Crank, No Start after rear interior work

[sapote]

update: checked voltage at the starter and there is 12V when not cranking. When I go to crank the car, the voltage drops to 0V. what would be causing this? voltage at the black wire terminal on the starter exists when cranking.

still stumped

Loose big cable.
Chech the voltage at fender post (and the battery cables) when crank

[ejendow]

update: checked voltage at the starter and there is 12V when not cranking. When I go to crank the car, the voltage drops to 0V. what would be causing this? voltage at the black wire terminal on the starter exists when cranking.

still stumped

[ejendow]

Charged the battery overnight, but this wasn't the issue unfortunately. Anyone have any ideas?

[ejendow]

Do you have sufficient charge in the battery? If you had everything out were the interior lights on draining the battery? Single click sounds like starter doesn't have enough juice to turn over.


Sent from my iPhone using Tapatalk

I should. I also tried using a jumper box, but for now I'm gonna charge the battery overnight and try again in the morning.

[karter16]

Hey guys looking to see if anyone has any suggestions for me. Today I had everything out of the rear interior: door panels, seats, shelf, etc. When I wrapped everything up and put the interior back together, the car no longer cranks or starts. I just get a single click.

I first assumed I messed with the fuel pump somehow since I had the bench out but this wasn't the case since I was able to activate it using my schwaben tool.

Is there some wiring that runs to or lives in the rear that I potentially messed up?

Do you have sufficient charge in the battery? If you had everything out were the interior lights on draining the battery? Single click sounds like starter doesn't have enough juice to turn over.


Sent from my iPhone using Tapatalk

[ejendow]

Hey guys looking to see if anyone has any suggestions for me. Today I had everything out of the rear interior: door panels, seats, shelf, etc. When I wrapped everything up and put the interior back together, the car no longer cranks or starts. I just get a single click.

I first assumed I messed with the fuel pump somehow since I had the bench out but this wasn’t the case since I was able to activate it using my schwaben tool.

Is there some wiring that runs to or lives in the rear that I potentially messed up?