Window not dropping when opening

[AWE46M3]

OP - did you get this figured out?

My passenger side has this issue. The window doesn’t drop when I open the passenger side door (snags against the seal when opening the door - I’m in the habit of lowering that window slightly to mitigate that.

The also doesn’t index and push up when the door is closed like my drivers side does.

My lights and door open/close sensors work correctly.

Small issue but I’m doing a window regulators refresh and want to get this issue fixed.

[sapote]

Didn’t get a chance to play around with it tonight, but hoping over the weekend. Would love to save a few hundred $$$ and hours by not having to replace the lock actuator.

Pretty sure you can save it as it is a Hall sensor and a moving magnetic material don't contact and no wear and tear. Maybe it needs a little adjustment for the sensor to detect the target.

[Hammerfang]

Didn’t get a chance to play around with it tonight, but hoping over the weekend. Would love to save a few hundred $$$ and hours by not having to replace the lock actuator.

[Tbonem3]

How's a lock actuator related to the window drop when door opened? Maybe the door open sensor inside the actuator?

I've been doing this a loooong time. It's almost always the door/lock actuator unit. Windows going wonky, lights, window not dropping/going back up when opening/closing the door. Door lock "stem" not going up and down. One door not locking when using the key fob.

[Hammerfang]

You've found the root cause: door open sensor is bad so GM5 doesn't know the door open to drop the glass. (Don't blame the GM5.)

Hoping I can clean/lubricate the actuator rather then needing to replace it.

[sapote]

Tried troubleshooting this tonight and noticed the interior lights don’t go on (unless I push the button by the moonroof) and the open door indicator also does not show the door as being opened.
.

You've found the root cause: door open sensor is bad so GM5 doesn't know the door open to drop the glass. (Don't blame the GM5.)

[Slideways]

My gut feeling is the GM5 module, it acts up independently on each side.

I just had mine redone, my passenger window stopped rolling down. I would click the window switch 100 times and on the 101st try it would go down like normal and always go back up without an issue. It also stopped dropping the 1/8" when the door was opened. GM5 repair fixed it, I was going to do the actuator/motor since I'm on the interior of my car but glad I tested it first. https://www.bmwgm5.com/GM3_Repair_Service.htm

^ This. Relays in the GM5 like to go bad. Once they are replaced, windows and door locks will be fully functional.

[WestBankM4]

My gut feeling is the GM5 module, it acts up independently on each side.

I just had mine redone, my passenger window stopped rolling down. I would click the window switch 100 times and on the 101st try it would go down like normal and always go back up without an issue. It also stopped dropping the 1/8" when the door was opened. GM5 repair fixed it, I was going to do the actuator/motor since I'm on the interior of my car but glad I tested it first. https://www.bmwgm5.com/GM3_Repair_Service.htm

[Slideways]

Tried troubleshooting this tonight and noticed the interior lights don’t go on (unless I push the button by the moonroof) and the open door indicator also does not show the door as being opened.

going to try and clean/lubricate the mechanism which shows if the door is open and see if that solves the problem.

If you or a friend have INPA, you can scan the GM5 for error codes.

[Hammerfang]

Tried troubleshooting this tonight and noticed the interior lights don’t go on (unless I push the button by the moonroof) and the open door indicator also does not show the door as being opened.

going to try and clean/lubricate the mechanism which shows if the door is open and see if that solves the problem.

[sapote]

Lock actuator in my experience.

How's a lock actuator related to the window drop when door opened? Maybe the door open sensor inside the actuator?

[Hammerfang]

Thanks guys, will check the pinch sensor but have a feeling it’s the door lock actuator.

[Tbonem3]

Lock actuator in my experience.

[bigjae46]

There's a pinch sensor in the door seal and the wire runs behind the a pillar cover. I'd remove the a pillar cover and check the wiring.

[LeeForst]

Window regulator potentially? I’m sure experts will chime