DIY: Suspension install videos

[Obioban]

Starring Dan Law of DER Motorsports

Rear suspension removal

Jacking

Trunk liner removal

Front suspension removal

Front sway bars

Front suspension installation

RTABs

Trunk liner removal

FCABs

RSM lubing

Tie Rods

Front strut assembly

Rear suspension install

Rear sway part 1

Rear sway part 2

[M3Bob]

My experience w/ the Bimmerworld Trackcabs (Delrin FCABS): you have to install the bushing further up the control arm than the 297-301mm recommended in the TIS. At least that was my experience and what it took to get the lollipops to line back up. Well, that plus putting some upward pressure on the wheel assembly w/ a floor jack.

It's also good to have a M10x1.5 threat chaser (or at the very worst, a M10x1.5 tap) to clean up the threads in the subframe.