Moton clubsport install help

[Seattleswimboy]

Hey guys, I am installing Moton clubsports and I am trying to figure out how to install the remote cans. I do not have quick disconnects and I want to install the rear cans in the trunk and the fronts up in front in the engine bay or right behind the kidney grills. Does anyone have any experience installing remote cans? I am thinking the fronts I could maybe run though the brake ducting though the fender liner up to the engine bay. The rear I don't see any spots that are even remotely large enough to run the cans though unless I hole saw some giant ass holes in the trunk floor which i really rather avoid if possible.
Any suggestions?

[Randall921]

I ran mine through the vents in the trunk on the bottom of the trunk. Just have to remove/trim the plastic vent piece. Part 8 in the diagram. It sits behind the bumper cover on the side of the trunk.

https://www.realoem.com/bmw/enUS/showparts?id=BL93-USA-01_2000_E46_BMW_M3&diagId=51_4783#64226962293

[Sergmann]

I also went through the vents into the trunk space. Just remove the fender liner and it should be quite obvious. the vents simply pop out and can be modified to allow the pass through.

[s14_kev]

Wow I literally just did this yesterday with the same setup. Here is what I did but YMMV.

Front:
remove the front bumper and loosen the headlights. You should be able to pull the headlights just enough forward to slide the cans up and into the engine bay. I mounted the driver side on the strut brace and the passenger side in the “drug bin”. I did have to dremel the fender liner to route the hoses when reinstalling the bumper.

Rear:
remove the rear bumper and pop out the plastic finned covers. You can probably do it with the bumper on but space is more limited. I dremeled little slits in the plastic for the hoses.

[Seattleswimboy]

Wow I literally just did this yesterday with the same setup. Here is what I did but YMMV.

Front:
remove the front bumper and loosen the headlights. You should be able to pull the headlights just enough forward to slide the cans up and into the engine bay. I mounted the driver side on the strut brace and the passenger side in the “drug bin”. I did have to dremel the fender liner to route the hoses when reinstalling the bumper.

Rear:
remove the rear bumper and pop out the plastic finned covers. You can probably do it with the bumper on but space is more limited. I dremeled little slits in the plastic for the hoses.

Perfect! Exactly what I was looking for! Thank you!