Announcement

Collapse
No announcement yet.

Black & Tan 332iT

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • George Hill
    replied
    Originally posted by 0-60motorsports View Post

    Nice! are they still making those headers?
    I think they've been out of production for 15+yrs

    Leave a comment:


  • 0-60motorsports
    replied
    Originally posted by George Hill View Post

    The only reason I initially S54 swapped my wagon was because I had a set of Kromer Kraft headers. They were old and tired but sounded amazing. They needed some repair and were pulled in favor of a "temporary" euro setup. I think that was 4yrs? ago, lol. My spring goal is to get them back on and I'm probably going to make a muffler to quiet everything down as I can't really buy anything I like at least that I can find.

    Going from E36 to ZHP, I think there's room on the table to make more power and be similar sound level even if you are guessing at some parts of the design. IIRC we saw a ZHP left 15whp on the table vs a Stromung conversion muffler, Dinan or BMW Performance mufflers (E36 was even more than that).
    Nice! are they still making those headers?

    Leave a comment:


  • Bry5on
    replied
    Originally posted by George Hill View Post

    What is a shear plate?
    That aluminum plate that ties the subframe to the frame rails. Which reminds me, I also want to design a flat sheet to close that M3 plate out and stiffen it up like the non-m plate

    Leave a comment:


  • George Hill
    replied
    Originally posted by Bry5on View Post
    I guess one of us needs to scan an s54 without headers installed with the shear plate....
    What is a shear plate?

    Leave a comment:


  • Bry5on
    replied
    Originally posted by George Hill View Post
    Unfortunately it makes no torque lol. HTE couldn't get it to make any power up top but I have some graphs from similar setups make a ton of HP up top (Epic Tune) so I'm not sure what the problem was. The consensus seems to be the 2-1 merge kills the torque but makes the noise so I'm conflicted haha. I was thinking about making a second 2-1 merge that is either bigger or to carry it out longer.

    I think this kit is for an E36 and I've made it work in the E46 chassis. I don't know how different it is from his E46 kit (or if there is a difference at all), but it would be hard to package in an E46. This one is going to require a custom A/C line (and I had to cut the metal partition).
    I guess one of us needs to scan an s54 without headers installed with the shear plate...

    Modeling equal length headers shouldn't be very tough and there are a few online suppliers that do custom mandrel bent tubing nowadays. Should be a lot easier now than it was back in the 2000s and 2010s.

    Leave a comment:

Working...
X