Up for sale is a set of 4 refinished and rebuilt Porsche 996 brake calipers made by Brembo. The calipers have been professionally stripped back to bare aluminum, powder coated in Brembo Red and rebuilt with new seals. These calipers, along with Rally Road adapter brackets, Rally Road brake lines and ZCP front rotors come together as an affordable BBK upgrade for the BMW E46 M3. Calipers are plug and play on an E46 M3, no additional work needed.
I had these made for my personal car to replace the painted set that is currently installed. Unfortunately I never got around to putting these on before the car went into winter storage. Looking to sell for now, may have another set made for me in the spring.
Part numbers for the calipers
• 996.351.426, 996.351.425 (front)
• 996.352.422, 996.352.421 (rear)
Front calipers have been machined 5.5 mm, and rear crossover lines have been swapped from left to right for installation on a BMW E46 M3.
There are a few small flaws in the finished product. One crossover line is slightly bent. Unfortunately I did not catch this before I sent these off to powder coating. It is fully functional and does not leak, and will not be visible once calipers are installed. A few of the fittings on the crossover lines also have minor marks from a wrench from reinstallation.
Approximately $1.5-1.8k of additional stuff is needed to complete the conversion in addition to these calipers. I have compiled a shopping list and can send this to the buyer. If your M3 is already a ZCP (Competition Package) car, and your rotors are still good, you can deduct $800 from the cost. Conversion will cost ~$3000 total. This is affordable in comparison to a real StopTech or Brembo setup which would cost $5k+.
There is a wealth of information regarding this conversion on this forum
https://nam3forum.com/forums/forum/m...bbk-conversion
https://nam3forum.com/forums/forum/m...ersion-install
Calipers come bare as shown, with no pads, dampeners or hardware.
I can provide the buyer a shopping list of where to buy all the necessary components.
Asking $1400 shipped.
I had these made for my personal car to replace the painted set that is currently installed. Unfortunately I never got around to putting these on before the car went into winter storage. Looking to sell for now, may have another set made for me in the spring.
Part numbers for the calipers
• 996.351.426, 996.351.425 (front)
• 996.352.422, 996.352.421 (rear)
Front calipers have been machined 5.5 mm, and rear crossover lines have been swapped from left to right for installation on a BMW E46 M3.
There are a few small flaws in the finished product. One crossover line is slightly bent. Unfortunately I did not catch this before I sent these off to powder coating. It is fully functional and does not leak, and will not be visible once calipers are installed. A few of the fittings on the crossover lines also have minor marks from a wrench from reinstallation.
Approximately $1.5-1.8k of additional stuff is needed to complete the conversion in addition to these calipers. I have compiled a shopping list and can send this to the buyer. If your M3 is already a ZCP (Competition Package) car, and your rotors are still good, you can deduct $800 from the cost. Conversion will cost ~$3000 total. This is affordable in comparison to a real StopTech or Brembo setup which would cost $5k+.
There is a wealth of information regarding this conversion on this forum
https://nam3forum.com/forums/forum/m...bbk-conversion
https://nam3forum.com/forums/forum/m...ersion-install
Calipers come bare as shown, with no pads, dampeners or hardware.
I can provide the buyer a shopping list of where to buy all the necessary components.
Asking $1400 shipped.
Attached Files
Comment