Quick help needed-jack point

[Cubieman]

So I'm in the middle of dropping my subframe and planned to roll it out the back as one unit however I don't have the vehicle quite high enough.

I figured I could either:

- Bolt the subframe back on and use the rear center jack point to raise the whole rear of the car and re-adjust the jack stands

Or

- Use a floorjack to jack the car up one side at a time, however with the jack stands on the jack pads I would be jacking the car in front of the jack pads, is this acceptable?

[thegenius46m]

Bolt the subframe back on temporarily. The alternative is sketch because the car will teeter totter.


Sent from my iPhone using Tapatalk

[Cubieman]

Bolt the subframe back on temporarily. The alternative is sketch because the car will teeter totter.


Sent from my iPhone using Tapatalk

That's what I'm thinking, at least I didn't move the subframe so it's more or less aligned and ready to go straight back up.


EDIT: Bolted subframe back on...feels like..



Live and learn..

[thegenius46m]

That's what I'm thinking, at least I didn't move the subframe so it's more or less aligned and ready to go straight back up.


EDIT: Bolted subframe back on...feels like..



Live and learn..

Yup I will tell you what happens if you don’t use the subframe. I’ve seen it at the yard lmfao!


Sent from my iPhone using Tapatalk