Car is a 2004/4 E46 M3 with new Slave cylinder, Electric motor and Gear position sensor.
I had just replaced my pressure plate and clutch, due to a previous faulty pressure plate.
After putting everything back together I went to start the car but it doesn't want to shift.
I read codes which were,
56: SMG Ventings
3B: SMG Actuation of dynamic clutch
23: SMG Hydraulic pressure sensor
I have noticed that the pump primes continually every 10 seconds,
The pressure goes no lower than 80 bar, when it primes it goes well past 100 bar.
Any help is welcome!
I had just replaced my pressure plate and clutch, due to a previous faulty pressure plate.
After putting everything back together I went to start the car but it doesn't want to shift.
I read codes which were,
56: SMG Ventings
3B: SMG Actuation of dynamic clutch
23: SMG Hydraulic pressure sensor
I have noticed that the pump primes continually every 10 seconds,
The pressure goes no lower than 80 bar, when it primes it goes well past 100 bar.
- I have tried another salmon relay, no luck.
- The car will sometimes successfully shift after 10 seconds of the gear flashing on dash.
- I had removed the slave cylinder to complete the installation of the transmission.
- I have bled both the actuator and slave multiple times. Sometimes it will fail causing a "break"
- Unable to complete the adaptations.
- Fluid level is OK.
Any help is welcome!
Comment