Rear Control Arm Droop

[Cronenberged]

Does anyone have a measurement of the distance from their rear top and bottom shock mount points with the sway disconnected? I need a rough idea of how much droop their is.

[cobra]

With the stock shocks installed?

[Cronenberged]

With the stock shocks installed?

Nothing installed. Knew I would forget to mention something.

[George Hill]

I don't also might want to note what bushings are in the RTABs, I found B/Js allow a decent amount more droop than bushings (and limiters).

[Cronenberged]

I don't also might want to note what bushings are in the RTABs, I found B/Js allow a decent amount more droop than bushings (and limiters).

Thanks George, yea mine have the AKG 95A poly, but I do plan to swap those for B/J.

[George Hill]

Thanks George, yea mine have the AKG 95A poly, but I do plan to swap those for B/J.

I guess along those lines IIRC mine with B/Js will bottom out with the LCA contacting the subframe

[fattycharged]

I can grab this for you later this evening

[Cronenberged]

I can grab this for you later this evening

Thank you.

[cobra]

I have stock RTABs. With shocks, springs, and wheels removed on both sides...

Center of the lower shock mounting bolt to the gasket surface of the RSM = 25.5"

[fattycharged]

Stock RTABs with limiters, shocks, springs, wheels and differential removed....forgot about that last part...

Without the differential in place, saw 27.5" from same measuring locations as cobra

[Cronenberged]

Thank you gents.

cobra were you measuring with or without your clevis?

fattycharged do you have the carrier removed and upper control arm removed as well?

[cobra]

Thank you gents.

cobra were you measuring with or without your clevis?

fattycharged do you the carrier removed and upper control arm removed as well?

No clevis. To the sheet metal of the chassis.

[fattycharged]

Thank you gents.

cobra were you measuring with or without your clevis?

fattycharged do you the carrier removed and upper control arm removed as well?

carrier and uca's still in place