Dumb Question Thread - No Flaming Allowed

[fourmula1]

Also DME 50 switch chain frictional connection

Yes, so that might always be there? I do have a good brown clutch switch off my race car in it.

I'm able to fire it up now when stomping on the clutch pedal and hitting the clutch stop. I pulled the stop and slowly went past where the stop would have been and it fired up. I'm thinking it was just barely seeing it and maybe the heat exacerbated it.

Still trying to figure out the airbag light and codes.

[ugaexploder]

Intermittent crank. Airbag light on. Windows aren't fully closing when door closes. White noise from speakers with power on engine off.

Battery died and airbag light appeared around the same time, replaced battery. Car was fine this morning. Went back out and wouldn’t turn over.

There was an ews immobilizer fault, but it cleared.

Help would be much appreciated. Definitely seems electrical in nature.

smg to 6spd conversion?

[fourmula1]

Intermittent crank. Airbag light on. Windows aren't fully closing when door closes. White noise from speakers with power on engine off.

Battery died and airbag light appeared around the same time, replaced battery. Car was fine this morning. Went back out and wouldn’t turn over.

There was an ews immobilizer fault, but it cleared.

Help would be much appreciated. Definitely seems electrical in nature.

Also DME 50 switch chain frictional connection

[fourmula1]

Intermittent crank. Airbag light on. Windows aren't fully closing when door closes. White noise from speakers with power on engine off.

Battery died and airbag light appeared around the same time, replaced battery. Car was fine this morning. Went back out and wouldn’t turn over.

There was an ews immobilizer fault, but it cleared.

Help would be much appreciated. Definitely seems electrical in nature.

[Slideways]

Curious, but what did you go with for boots and clamps? I bought the turner silicon ones, then returned them and ordered the OE boots and clamps...

Found a good set of boots off a used SMG intake lol. Even was able to reuse the one time use clamps on the intake side since they can be bent back with a little heat and pliers. The Norma worm clamps are also an option if you don't want to use the original clamps and buy the ear clamp tool. For the worm clamps, you have to tighten them snug to the point where the boot still can rotate a small amount, just don't go crazy tight.