I am stuck with DOOR AJAR warning

[Mrgunfun]

All of sudden, my driver side door sensor decided to give up and now throwing DOOR AJAR warning all the time.
.
The problem is my car has an SMG and would not shift into a gear since the car thinks the door is opened.

Is there a way to get around or disable this sensor so I can at least move the car? (maybe disconnect fuse?)

Please help!!

[CrbnBlkM3CT]

Were you able to figure out a work around to this issue? I'm experiencing the same issue and hoping that maybe pulling a fuse will work for now.

[Pnick]

Along with several other signals that the SMG unit require to get a START ENABLE or GEAR CHANGE, there is a "HALL EFFECT" DOOR position sensor integrated in the door latch which sends the signal to the GM (General Module). This data is transferred via the K-Bus and CAN Bus for safety program initiation. This sensor is likely faulty.

[CrbnBlkM3CT]

Thanks for your response Pnick. I wasnt sure if this was a door latch sensor issue or GM5 issue. Based off of your response it sounds like a door latch sensor issue. I don't know if this makes any difference but im able to move my car but the SMG gear position number on the dash flashes the whole time.

[Pnick]

Check the sensor on the door latch. I had the same issue while I was in motion on mine but it was the hood that came slightly open (the hood switches weren't actuated for that) and I was still able to change gears but it continued to flash until I stopped and closed the hood all the way. Then, all was good. I highly suspect it's the door latch sensor.

[CrbnBlkM3CT]

Very good... I will check the latch. I'm leaning that way as well. Thank you