ZHP rack coding

[Cubieman]

I have M-Track mode coded I remember when doing so I set it up for my green tag rack. If I go to a ZHP rack what value or "wert" should I be using? Thanks.

It's currently set to "wert_05" under "LENKWINKELKENNLINIE_2" in the MK60 module.

Edit: It's "wert_04", found it searching around, thanks heinzboehmer.

[thegenius46m]

I have M-Track mode coded I remember when doing so I set it up for my green tag rack. If I go to a ZHP rack what value or "wert" should I be using? Thanks.

It's currently set to "wert_05" under "LENKWINKELKENNLINIE_2" in the MK60 module.

Use the ZCP rack setting. The ratio ends up being the same when connected to M3 spindles.

[Tbonem3]

Use the ZCP rack setting.

Which is....?

[Cubieman]

I *MAY* have taken note as to which setting it was when M-track mode was programmed before I changed it, but the value would be nice.
Also, on another note aren't the ZCP and ZHP different ratios?

[terra]

The actual ZCP and zhp cars have different ratios, but the racks have the same travel for each turn of the pinion. The suspension geometry differences between the M and non-M make the rest of the difference.

[thegenius46m]

The actual ZCP and zhp cars have different ratios, but the racks have the same travel for each turn of the pinion. The suspension geometry differences between the M and non-M make the rest of the difference.

Comes down to the lever arm ratio on the knuckles. I own a zhp sedan and have a low mile zhp rack in the m3 and the sedan steering is noticeably faster.

[thegenius46m]

Which is....?

Set LENKWINKELKENNLINIE_2 to wert_04 for ZCP or ZHP steering rack. Either rack installed onto an M3 is a calculated 14.5 steering ratio so the steering angle sensor will not complain.

[BMWahba]

I wasn't aware if the the MK60 cars need the yellow tag coded? Or is it plug and play?

[Tbonem3]

No, it'd still need it. Only ZCP wouldn't, but why would you swap yellow for blue?

That said, I have mk60 and yellow tag, with no coding, and DSC only intervenes in spirited driving where I would have DSC off anyway.

[thegenius46m]

I wasn't aware if the the MK60 cars need the yellow tag coded? Or is it plug and play?

Only a real ZCP car would not need it coded but honestly the ZHP rack is a complete waste on those cars unless the ZCP rack develops play and needs to be replaced since new isn’t really an option.


Sent from my iPhone using Tapatalk