MSS54HP required for MAP?

[heinzboehmer]

Bringing this one back.

Can I have Kassel perform just the MSS54 to MSS54HP upgrade and then use either the Mullet or HTE tune, or must I also have Kassel install the CSL software as well?

Either works. Bryson can remote flash the full CSL FW if needed.

You just need to make sure they return your DME to you with something on it. The HW conversion involves physically replacing the ROM with new blank chips, which means that the DME will need to be bench flashed before it can communicate with the typical flashing tools.

[D-O]

MSS54HP DME with CSL software is required to install a MAP sensor. Kassel should be able to do the conversion. After the conversion, HTE can tune the DME.

Bringing this one back.

Can I have Kassel perform just the MSS54 to MSS54HP upgrade and then use either the Mullet or HTE tune, or must I also have Kassel install the CSL software as well?

[Slideways]

MSS54HP DME with CSL software is required to install a MAP sensor. Kassel should be able to do the conversion. After the conversion, HTE can tune the DME.

[ramadox]

Hello, just getting stuff gathered for a karbonius install, i have an MSS54 ecu and am trying to figure out the easiest way to add a MAP sensor. Is this possible if i go with just an HTE tune or do i need to convert to MSS54HP ecu first?

If this is not an option, then the next option would be to send it to a place like kassel to be converted. Would i need to get the csl tune on top of that, or can i have him send me back the converted ecu to get a hte tune? any other tips would be appreciated, thank you