I measured the V2 kit for GKNV2 unit
Steel Plates - 1.03 mm (5)
Thick steel plate: 2.02mm (1)
...
Announcement
Collapse
No announcement yet.
Search Result
Collapse
500 results in 0.1090 seconds.
Keywords
Members
Tags
-
Last edited by maupineda; Yesterday, 05:17 AM.
-
The new kits (Version 2) have the free play shim, which is just a Belleville washer, and another on the pump side. This is something they seem to have...Last edited by maupineda; 04-30-2024, 03:37 PM.
Leave a comment:
-
Specifically to the GKN V2 LSD; it is 100NM for their V1 rebuild kit, and 125NM for their V2.
The GKN V2 unit has more clutches and steel...
Leave a comment:
-
I pressed the E36 bushings, it was pretty annoying at first as I tried to use a c-clamp tool and it did work partially, but it was not the right tool...
- Likes 2
Leave a comment:
-
I took a few moments to measure backlash on what I assume is the factory setup.
it was .0025 to 0.003in, or 0.06 to 0.07mm so I know what...
- Likes 2
Leave a comment:
-
-
You can install a voltage emulator and see if that makes ISTA work. It did for me on my F900R motorcycle to be able to resent service schedule.
...
Leave a comment:
-
I have measured breakaway torque on the spare diff and it read 65nm or 48 ft/lb. Not sure that is ok, or too low.
...
Leave a comment:
-
I run future classics and yes, they are very expensive, I actually got a used set and that was better value. the set screw is a neat feature, but also...
Leave a comment:
-
-
Do you have the flange that is not welded? Is not shown in the photo.
Leave a comment:
-
I thought the same, I think you need a flat surface to have sufficient area for the shear pump to press the clutches, the be level spring would affect...
Leave a comment:
-
Super helpful!!!!
do you think is the sheer pump that is broken? To my knowledge the M Variable diffs can lock to 100%...
Leave a comment:
-
So, after thinking about this much and reading the feedback from other as well as doing my own research here are some of the key things to do this right....Last edited by maupineda; 04-13-2024, 09:42 AM.
Leave a comment:
-
I have been going down the mental rabbit hole about rebuilding the diff, and the more go about it, the more I doubt to venture in it, not for the difficulty...
Leave a comment:
Leave a comment: