FS: Porsche 996 Brembo Front/Rear Calipers - BBK Upgrade for E46 M3 - $OLD

[Titaniu//M]

Up for sale is a set of Brembo brake calipers off a Porsche 996. These are commonly used as a brake upgrade on E46 M3s, as a budget friendly BBK solution. There is a wealth of information available regarding this conversion here on this forum in the threads below. In short, in addition to these calipers, adapter brackets, brake lines, ZCP front rotors and some machining work will need to be done to fit these on an E46 M3.

https://nam3forum.com/forums/forum/m...bbk-conversion

https://nam3forum.com/forums/forum/m...ersion-install

Part numbers:

• Front - 996.351.425 ; 996.351.426
• Rear - 996.352.421 ; 996.352.422

The calipers have 70,785 miles and were removed from a wrecked Porsche. Calipers have been cleaned, inspected and tested. All are in good working condition with no frozen pistons, blown seals or torn dust boots. Calipers are as-removed from a Porsche and no work has been done to them. At a minimum, the fronts will need to be machined 5.5 mm and the rear crossover lines will need to be flipped left to right to install these on an E46 M3. I can have this done before I ship the calipers out for a small fee.

Cosmetically, the paint is faded and bubbling in a few places on the calipers. Most people will want to paint the calipers before install. No major damage to any of the castings. 1 bleeder screw cap is torn.

Includes a set of nearly new pads, caliper hardware, pad dampeners and pad wear sensors.

Asking $OLD shipped for the calipers, or $OLD picked up in Columbus, OH.

[Titaniu//M]

Bump

[Harrymadan]

Hey. A quick question
What size spacers and bolts will be needed to mount these brakes.

[Titaniu//M]

Hey. A quick question
What size spacers and bolts will be needed to mount these brakes.

Depends on what wheels you have. Stock ZCP is 15 mm w/extended bolts in the front I believe.

[Titaniu//M]

Bump