What’s the OEM RACP part number

[BL92]

You need a spot weld drill bit and a spot weld chisel to separate the layers.

Also, check post #11 of this thread. You don't need to transfer the rear trailing arm pockets. But you would need a jig to reinstall the "new" panel and make sure it's perfectly align. I can sell my jig but shipping to Austalia would be crazy expensive!

The jig would also help with the install cause you can hold it on the car bolted in the RTA pockets and than put jack stand under the jig and use the weight of the car to put pressure so the RACP has no gap with chassis while welding

Legend, Thanks GT, I will grab both

How much to post the Jig, I am curious, I am in South Australia 5046


Thanks

[Gt4]

Legend, Thanks GT, I will grab both

How much to post the Jig, I am curious, I am in South Australia 5046


Thanks

The jig is at my 2nd house. I will try to measure/weight it next week and get a shipping quote

[Gt4]

Finally can't find shipping quote that make sense... UPS/DHL are like $8500... LOL