What did you do for your M3 today?

[fattycharged]

Would love to hear how these improved things, my clutch and brake pedal may need the same.

They tighten up any side to side, the bmw sleeve wears over time, 120k miles worth of clutch in/out, the brake pedal sees less wear in my instance.

I printed them in two materials, an abs with cf additive (not a great choice for this location but it's what was loaded at that moment) and a PA12 CF which should be a better fit for this application and what I'll install.
Best would likely be PEEK, but I'm limited to a 300c print temp, so that's off the table for my inexpensive RAISE3D pro

For a sane individual, buying a set of $20-40 a pop Delrin bushings from one of the suppliers would make the most sense


Sent from my iPhone using Tapatalk

[CarbonSchwartzenegger]

Clutch pedal was a bit loose, was ordering some small parts this week and realized no real options for getting things to me before weeks end, so thought why not try and 3D print something, I never really use it for anything these days….

Half hour later, some clutch/brake pedal bushings I'm going to try out.

Would love to hear how these improved things, my clutch and brake pedal may need the same.

[CarbonSchwartzenegger]

Guys I finally did it. The stock diff had drove me nuts for the life of ownership with it's clunking. Diffsonline rebuilt with a wavetrac and no more clunk, drives so wonderful at the moment, now awaiting break in period. Pocket book has a hole in it but had to do it right.

[Gt4]

New OEM CSL knuckles with dust shields, bearings, ...

[6speedS54]

Transmission fluid change, CDV delete