MSS5x Binary Modification Tool Update

[Slideways]

I would love to use the tool but sadly my ecu is encrypted and bmwflasher cant pull a usable file from it.

Who tuned it?

[Mspir3d]

I would love to use the tool but sadly my ecu is encrypted and bmwflasher cant pull a usable file from it.

[SWRT_M3]

Shoot me another email, I get pretty snowed down when I’m super busy so things slip through the net.

thanks Martyn. applied the license you sent me this morning, keep up the great customer service.

[Martyn]

Shoot me another email, I get pretty snowed down when I’m super busy so things slip through the net.

[SWRT_M3]

how can i get new license to put on new computer have old license number but it just says wrong computer

Same here, I need to install it on a W10 laptop not that my old W7 laptop finally gave out.

I emailed Martyn a little over a week ago and haven’t gotten a reply yet

[Steveb]

how can i get new license to put on new computer have old license number but it just says wrong computer

[8000RPM]

Looking into this for the first time, does this allow setting all I/M monitors to ready?

[Martyn]

They are visible on all of my test VMs and workstations buddy.

[Amalgam]

Martyn I noticed a small bug with the latest download - the temperature window for the warm-up lights is missing. I was using version 1.3 previously and I could see the slider values in Celsius

[Amalgam]

Hey Guys,

So I've been fighting with this Secindary Air Pump and I'm not sure how to get this readied up for emissions. I've allowed the cold start and the DTCs to show (I've deleted my SAP), as Terra said to let the check engine light show, then delete, and I should be good.

I'm finding that when the CEL comes on, the SAP reads ready, but when I delete it, all DTCs go back to non complete (all tests are reset). I've included pics to illustrate the situation. So the CEL is on now, what should I do?

Thank,
Kareem

I was able to get mine to show as ready - I'll pull my config this weekend and let you know.

EDIT: I was able to check and I flashed cold start enabled but with the SAP DTCs turned off (I never let the CEL show) and my monitor is ready

[x Spades x]

Bueller? lol

I need of some help, anyone?

[x Spades x]

Hey Guys,

So I've been fighting with this Secindary Air Pump and I'm not sure how to get this readied up for emissions. I've allowed the cold start and the DTCs to show (I've deleted my SAP), as Terra said to let the check engine light show, then delete, and I should be good.

I'm finding that when the CEL comes on, the SAP reads ready, but when I delete it, all DTCs go back to non complete (all tests are reset). I've included pics to illustrate the situation. So the CEL is on now, what should I do?

Thank,
Kareem

[x Spades x]

Anyone?

[x Spades x]

If you delete the error code without actually turning it off in the tune, it'll read as ready after your first cold start

After I clear the code... and perform the next cold start... will the state be ready and the CEL stay off forever, or will the CEL eventually come back and turn the state back to "not ready"?

[x Spades x]

I have cats that I care about (deeply) as well as a functioning EGT sensor, thanks Martyn!

Lmfaoooo