Induktiv Wireless device charging unit

[jbfrancis3]

It still looks like a prototype

[t3ddftw]

It still looks like a prototype

Other than the fitment issues, I think it look substantially less like a prototype if you remove that weird 3D-printed-esq liner from the cup holder.

[elbert]

https://www.mouser.com/ProductDetail/TE-Connectivity/1-962692-2?qs=Q0GhXaox%252BNGwCY7XRxtywQ%3D%3D

You'll need some terminals too: https://www.newark.com/amp-te-connec...5?st=1355719-1

https://www.te.com/usa-en/product-1355719-1.html

-Ted

Awesome, thank you!
I was wondering why you didn't link Mouser for the terminals, until I realized their minimum order was 13k units! Looks like Newark has the connector too.

[jbfrancis3]

Other than the fitment issues, I think it look substantially less like a prototype if you remove that weird 3D-printed-esq liner from the cup holder.

Mike knows exactly where its going and what the factory BMW finish is. Its too bad its still well far off from blending in.

[0-60motorsports]

Hope mine does not look like that or it’ll not be going in

[duracellttu]

Anybody else’s OCD ticking after noticing the U logos pointed in different directions? I can’t unsee it now.

[INDUKTIV]

Got mine installed. Everything works as described. Phone charges well. Connectors are plug and play.

Fit and finish is far from perfect lol. Not bad, but not good either.

This one section on passenger side has small gap, not noticeable unless you look at it eye level. Overall the added feature and cup holder is good enough for me to want to keep it on.





Sent from my iPhone using Tapatalk

try sliding it back a bit. we had to leave little play if we didn't you would not be able to remove the unit.

as far as finish goes we wanted to keep the unit raw plastic if possible to prevent wear and make the unit last.

[INDUKTIV]

Anybody else’s OCD ticking after noticing the U logos pointed in different directions? I can’t unsee it now.

the cup holder is removable for cleaning and can be reversed.

[Toby22]

try sliding it back a bit. we had to leave little play if we didn't you would not be able to remove the unit.

as far as finish goes we wanted to keep the unit raw plastic if possible to prevent wear and make the unit last.

I did that but no luck. Even when I push it down it doesn’t close the gap

[Toby22]

Hope mine does not look like that or it’ll not be going in

If your finish end up looking better than mine, then I will want an exchange lol. If you already pre-ordered I assume it’ll look like how mine does (finish wise at least)

[0-60motorsports]

If your finish end up looking better than mine, then I will want an exchange lol. If you already pre-ordered I assume it’ll look like how mine does (finish wise at least)

I did preorder but it didn’t ship yet

[Toby22]

I did preorder but it didn’t ship yet

Post yours up if you can once it arrives. I’m curious as well

[0-60motorsports]

Post yours up if you can once it arrives. I’m curious as well

Will do

[Toby22]

Here’s a better representation of the console. Did a quick wipe down and took pics from different angles.







Sent from my iPhone using Tapatalk

[Obioban]

Mine shipped yesterday.

I'm hoping the finish is not noticeable with the contrast to stock, and more durable, in the M3 with Imola center console:


But for the wagon, at least, with stock center console, I suspect I'm going to send it to TexaZ3 for his refinishing surface.
https://nam3forum.com/forums/forum/c...ch-restoration