Announcement

Collapse
No announcement yet.

Induktiv Wireless device charging unit

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #76
    It still looks like a prototype
    '05 M3 Convertible 6MT, CB/Cinnamon, CSL Airbox&Flap, PCSTuning, Beisan, Schrick 288/280, SS V1's & 2.5" System, RE Stg 1&SMF, KW V2, CB PS, Apex EC-7R

    Comment


      #77
      Originally posted by jbfrancis3 View Post
      It still looks like a prototype
      Other than the fitment issues, I think it look substantially less like a prototype if you remove that weird 3D-printed-esq liner from the cup holder.

      Comment


        #78
        Originally posted by t3ddftw View Post
        Awesome, thank you!
        I was wondering why you didn't link Mouser for the terminals, until I realized their minimum order was 13k units! Looks like Newark has the connector too.

        Comment


          #79
          Originally posted by t3ddftw View Post

          Other than the fitment issues, I think it look substantially less like a prototype if you remove that weird 3D-printed-esq liner from the cup holder.
          Mike knows exactly where its going and what the factory BMW finish is. Its too bad its still well far off from blending in.
          '05 M3 Convertible 6MT, CB/Cinnamon, CSL Airbox&Flap, PCSTuning, Beisan, Schrick 288/280, SS V1's & 2.5" System, RE Stg 1&SMF, KW V2, CB PS, Apex EC-7R

          Comment


            #80
            Hope mine does not look like that or it’ll not be going in

            Comment


              #81
              Anybody else’s OCD ticking after noticing the U logos pointed in different directions? I can’t unsee it now.
              2005 BMW M3 ZCP Black/Black - HTE Tuning | Kassel CSL DME | 288/280 Schrick Cams+DLC Followers | Lang Head | Dinan TBs | Bosch 550cc | Radium Fuel System | Karbonious CSL Airbox+OE Snorkel | SS V1 Stepped+Catted Sec 1+Resonated Twin Pipe+Race | 3.91, 3 stage clutch | FCM 400/600 | Vorshlag Camber Plates, RSM | Rogue ASP | AKG FCABs, SFBs | TMS Front Sway, Camber Arms, Monoball RTABs, Pullies | Mason Race Strut + X-Brace | AS 30% SSK | SPAL | Redish Plates | Turbo Toys V2 Hub | WPC Rod Bearings

              Comment


                #82
                Originally posted by Toby22 View Post
                Got mine installed. Everything works as described. Phone charges well. Connectors are plug and play.

                Fit and finish is far from perfect lol. Not bad, but not good either.

                This one section on passenger side has small gap, not noticeable unless you look at it eye level. Overall the added feature and cup holder is good enough for me to want to keep it on.





                Sent from my iPhone using Tapatalk
                try sliding it back a bit. we had to leave little play if we didn't you would not be able to remove the unit.

                as far as finish goes we wanted to keep the unit raw plastic if possible to prevent wear and make the unit last.


                Comment


                  #83
                  Originally posted by duracellttu View Post
                  Anybody else’s OCD ticking after noticing the U logos pointed in different directions? I can’t unsee it now.
                  the cup holder is removable for cleaning and can be reversed.

                  Comment


                    #84
                    Originally posted by INDUKTIV View Post

                    try sliding it back a bit. we had to leave little play if we didn't you would not be able to remove the unit.

                    as far as finish goes we wanted to keep the unit raw plastic if possible to prevent wear and make the unit last.

                    I did that but no luck. Even when I push it down it doesn’t close the gap

                    Comment


                      #85
                      Originally posted by 0-60motorsports View Post
                      Hope mine does not look like that or it’ll not be going in
                      If your finish end up looking better than mine, then I will want an exchange lol. If you already pre-ordered I assume it’ll look like how mine does (finish wise at least)

                      Comment


                        #86
                        Originally posted by Toby22 View Post

                        If your finish end up looking better than mine, then I will want an exchange lol. If you already pre-ordered I assume it’ll look like how mine does (finish wise at least)
                        I did preorder but it didn’t ship yet

                        Comment


                          #87
                          Originally posted by 0-60motorsports View Post

                          I did preorder but it didn’t ship yet
                          Post yours up if you can once it arrives. I’m curious as well

                          Comment


                            #88
                            Originally posted by Toby22 View Post

                            Post yours up if you can once it arrives. I’m curious as well
                            Will do

                            Comment


                              #89
                              Here’s a better representation of the console. Did a quick wipe down and took pics from different angles.







                              Sent from my iPhone using Tapatalk

                              Comment


                                #90
                                Mine shipped yesterday.

                                I'm hoping the finish is not noticeable with the contrast to stock, and more durable, in the M3 with Imola center console:
                                Click image for larger version  Name:	fetch?id=84095&d=1612965953.jpg Views:	0 Size:	130.3 KB ID:	95130

                                But for the wagon, at least, with stock center console, I suspect I'm going to send it to TexaZ3 for his refinishing surface.
                                https://nam3forum.com/forums/forum/c...ch-restoration

                                2005 IR/IR M3 Coupe
                                2012 LMB/Black 128i
                                2008 Black/Black M5 Sedan

                                Comment

                                Working...
                                X