MSS6x Flasher - Now released!

[Paddy]

have now ordered a cable with EdiabasLib firmware. thank you

[Martyn]

You can try and get the SK depending on whether its responding, I personally woudn't try writing with that cable though.

[Paddy]

I need more information. What steps did you take, what cable do you have, are you using the latest version?

I had to reflash the ECU in WinKFP.
the ecu has water damage. can i get the ews. copy?
I got cables from doitAuto. never had any problems with

[Edouard]

THX Terra work great

[tdott]

A big compliment to Terra

For the less inclined, what is this showing?
Is it a modified file being flashed with WinKFP?
Was this after using a backup from MSSFlasher?

[jumper]

A big compliment to Terra

[terra]

Hi, I see this question has been asked before (but as far as I can find hasn't been answered).

This seems like a great tool! I'm wondering if it's possible to use an ICOM instead of a K+DCAN cable (I have both but my K+DCAN cable is from one stop electronics).

Since normally flashing an ICOM with WinKFP etc. is considered to be safer... I would prefer this option if recommended. Do you have any experience with using an ICOM with your tool? And with your latest update the "Port setting" in the config file should be changed, right?

Unfortunately no ICOM support since EdiabasLib doesn't support ICOM.

You should be able to leave the port setting alone unless you have multiple FTDI devices connected at the same time.

[TNLB7]

Hi, I see this question has been asked before (but as far as I can find hasn't been answered).

This seems like a great tool! I'm wondering if it's possible to use an ICOM instead of a K+DCAN cable (I have both but my K+DCAN cable is from one stop electronics).

Since normally flashing an ICOM with WinKFP etc. is considered to be safer... I would prefer this option if recommended. Do you have any experience with using an ICOM with your tool? And with your latest update the "Port setting" in the config file should be changed, right?

[jamam5]

All good ! on second try everything went ok. i was able to write tuned file with no problem . Thank you for this tool!

[jamam5]

Read full from MSS60 , and tried to write same tune file ( not modified) and had error. Anything i did wrong ?

[jamam5]

BDM unfortunatly dont read one of the MPC . as i know its locked by BMW

[terra]

Hello , first of all thank you for this amazing app, i was able to read full data out of my damaged mss60 . Question , if i write this full data to other dme with same part number will it be full clone of my dme ?

No the truly individual data is untouched. It's just the program that would be rewritten. You'd need a BDM tool to do the rest.

[jamam5]

Hello , first of all thank you for this amazing app, i was able to read full data out of my damaged mss60 . Question , if i write this full data to other dme with same part number will it be full clone of my dme ?

[terra]

i have a problem with mss65


that happens when i make flash

I need more information. What steps did you take, what cable do you have, are you using the latest version?

[1984M3]

i have a problem with mss65


that happens when i make flash

Did you figure it out? In the posts above with my mss60, I had to reflash the ECU in WinKFP. I've not yet re-attempted flashing (RSA Bypass) on version 1.0.0.3 yet.