Originally posted by davidinnyc
View Post
Announcement
Collapse
No announcement yet.
Windshield cowls back in stock
Collapse
X
-
Here are a couple pics of Amazon vs original OEM on my 2002.
The clips I ordered from the dealer based on RealOEM were wrong so I reused the original.
Differences: the Amazon cowl has the grommets around the wiper motor post molded in (vs OEM cowl where the grommets were a separate piece). The Amazon cowl is missing a seal on the underside. Other than that it seems very similar.
Clip on right is original, left is that I ordered:
Last edited by YYZ-M3; 01-24-2026, 08:25 AM.
- Likes 1
Comment
-
The seal is what seals the water from running down into the engine bay. Likely no a big deal, but definitely not ok. The clips which you ordered are correct - they are the inner part only.Originally posted by YYZ-M3 View PostHere are a couple pics of Amazon vs original OEM on my 2002.
The clips I ordered from the dealer based on RealOEM were wrong so I reused the original.
Differences: the Amazon cowl has the grommets around the wiper motor post molded in (vs OEM cowl where the grommets were a separate piece). The Amazon cowl is missing a seal on the underside. Other than that it seems very similar.
Clip on right is original, left is that I ordered:
BMW / E46M Interior & Trim Restoration.
https://nam3forum.com/forums/forum/c...ch-restoration
- Likes 2
Comment
-
I think the real market for these will be collision and windshield replacement shops. The one time I had water incursion was on my Allroad 4.2 right after I had a windshield replaced. It was from an improperly installed seal — the smell of the water tipped me off before any computers could get wet under the passenger wheel well.
For this car, I’ve replaced this part with OEM back in the day but I’m sure I’ll need to do it again. Nothing about it said “once in your ownership fix.” So my view is if they fit, assume they’ll be like brake pads and move on with life, have a good day.
maw
- Likes 1
Comment
-
Best way to do that is the push the wiper FLAT to the windshield... then rock left/right (west/east). They come out in like 15 seconds. The key is to PUSH THE WIPERS FLAT. This takes the tension off of the nut.Originally posted by YYZ-M3 View PostHardest part of the job was getting the aluminum tapered shim out from the wiper arm :/
Comment
-
Don't push to hard or you can break the windshieldOriginally posted by x Spades x View Post
Best way to do that is the push the wiper FLAT to the windshield... then rock left/right (west/east). They come out in like 15 seconds. The key is to PUSH THE WIPERS FLAT. This takes the tension off of the nut.
'09 HP2S, '12 R12GSA, '00 Black 323iT, '02 Alpine 325iT (Track Wagon), '02 Alpine 330iT
Instagram @HillPerformanceBimmers
Email to [email protected]
- Likes 1
Comment
-
Originally posted by YYZ-M3 View PostThat worked for the drivers side. Pass side was a bear.BMW / E46M Interior & Trim Restoration.
https://nam3forum.com/forums/forum/c...ch-restoration
- Likes 1
Comment
-
Mines been here a week or so, I just havent taken it out of the box yet.'09 HP2S, '12 R12GSA, '00 Black 323iT, '02 Alpine 325iT (Track Wagon), '02 Alpine 330iT
Instagram @HillPerformanceBimmers
Email to [email protected]
Comment
-
I got my Bremmen out of the box today and it looks pretty good. It didn't come with the clips like a BMW or the foam seal on the back side but otherwise like's quite decent. Certainly not as good as a BMW part but will likely be just fine for 99% of the population.
***Edit, I wouldn't be against buying another when the time comes. Next up will be seeing how the sedan version compares.'09 HP2S, '12 R12GSA, '00 Black 323iT, '02 Alpine 325iT (Track Wagon), '02 Alpine 330iT
Instagram @HillPerformanceBimmers
Email to [email protected]
- Likes 1
Comment
-
Curious to know how this compares to the Amazon one since people are saying they could likely be from the same factory/manufacturerOriginally posted by George Hill View PostI got my Bremmen out of the box today and it looks pretty good. It didn't come with the clips like a BMW or the foam seal on the back side but otherwise like's quite decent. Certainly not as good as a BMW part but will likely be just fine for 99% of the population.
***Edit, I wouldn't be against buying another when the time comes. Next up will be seeing how the sedan version compares.
Comment
-
simon_c maybe, probably? I don’t have an Amazon acct and am happy with the service from ECS, so I likely won’t ever have an Amazon to compare.'09 HP2S, '12 R12GSA, '00 Black 323iT, '02 Alpine 325iT (Track Wagon), '02 Alpine 330iT
Instagram @HillPerformanceBimmers
Email to [email protected]
Comment

Comment