NCS expert - value remains aktiv even if I changed it to nicht_aktiv

[E46m3zcp]

As some of you might have seen on my original post: https://nam3forum.com/forums/forum/m...no-crank-issue
I am struggling with a no-crank condition.

In an attempt to further troubleshoot, I'd like to code the EWS to ignore the clutch switch, following this: https://www.e46fanatics.com/threads/...witch.1313143/

I'm following these steps with NCS Expert (my install doesn't have an "expert profile" but a profile named "default profile", which I assume is the same).

I am changing PARK/NEUTRAL_EINGANG from aktiv to nicht_aktiv, and everything seems to go well, no error or anything, I copy my stuff from the TRC file I have read with CODIERDATEN_LESEN to the MAN file I created blank at the beginning of the process, then I run the SG_CODIEREN job, everything finishes with no error.

But when I run the CODIERDATEN_LESEN again, that parameter is still aktiv. This is driving me nuts, what am I missing? Is the EWS not codable or something like that?

I switched the car on / off, I even unplugged/plugged back the EWS to be fully sure it has powercycled.

[Tbonem3]

You probably are still in factory mode when you need to be in Manipulation mode. Not for the editting of the txt file, but for flashing it back with codierndaten_lesen.

So you need 2 profiles, one expert or default for reading trc file and then a manipulation to send it back to the car.

You can find profiles online and add them to the proper ediabas/NCS folder or you can make your own and make sure you check the box for MANIPULATION.

[E46m3zcp]

Just wanted to thank you as this did the trick.