Rod bearings

[JudahJD904]

turner motorsports is the end all to be all diy. http://bd8ba3c866c8cbc330ab-7b26c6f3...n_-_Turner.pdf

[fattycharged]

Good looking out, have not seen this before and very nice write up with printout that's actually useable.


Sent from my iPhone using Tapatalk

[et89]

I have found all the info I need, except for one thing.

For the M10 bolts, sequence is 5nm - 30nm - 105 degrees (3x)
However, for this I am using a digital torque wrench with a gyro so it can measure the 105 degrees.
This wrench can take a max of 80nm. I have written a programm so it will start measureing 105 degrees from 30NM.
I'll undershoot the 30Nm torquestep by a small margin.

Does anyone know if this (80nm max) is enough to reach the 105 degrees?

[George Hill]

Does anyone know if this (80nm max) is enough to reach the 105 degrees?

Final torque will be over 80nm.

[et89]

Final torque will be over 80nm.

Thanks, just tested it. I programmed a limit of 75nm and it reaches that limit on ~75degrees

gonna need to do this with the old fashioned gauge and breaker bar.

[George Hill]

gonna need to do this with the old fashioned gauge and breaker bar.

Nothing wrong with that, I did a lot that way back during the recall days.