If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Ordered a new motion sensor bracket to replace the original which had worn out causing the unit to come loose; hoping I can just replace the bottom without needing to open up the headliner and switch out the top.
It's a 110k mile car that I bought at 80k, daily drove and repaired small items for 2 years, but it hadn't had any of the big issues addressed. I started on the vanos and cooling system in 2014, which took me almost 2 years to complete (second kid, house addition). A couple years later I got the RB done. Then this spring I finally bit the bullet and took care of the remaining big issues. I still drove it on occasion, but it was always hesitantly because of the risk the vanos tabs would break, or I'd spin a bearing, or every hard shift would tear the RACP a little bit more. The handling was also sketchy AF. In the middle of all that I also added an evolve CF airbox running on MAP, and a supersprint exhaust (I'm a sucker for good BF deals). The car isn't "done" by any means, but it's getting closer to what I envisioned over a decade ago.
It's been a long time coming, so yeah, it's nice to have it back.
I hear you man, bought mine in 2012, got married, then built a house, first kid second kid, it all takes time
Comment