Announcement
Collapse
No announcement yet.
Search Result
Collapse
70 results in 0.0076 seconds.
Keywords
Members
Tags
-
So my driver seat is getting pretty worn out. I very much regret not doing an interior swap to something more exciting than blah gray, but I don't know...
-
I think if you drain everything (including the engine block) then it takes around 8-10L of diluted coolant (1:1 coolant to water) to refill. The OEM...
- Likes 1
Leave a comment:
-
-
-
Thanks...that was my guess (either the front or the back). I've got a couple of the plastic trim pieces over the RTABs to put back next time the car...
Leave a comment:
-
Pros: sweet handling and easier to work on/adjust
cons: probably will have shorter service intervals and you’re stuck while the rebuild is ...
- Likes 1
Leave a comment:
-
Recording this for posterity...just in case someone else runs into the problem.
I tried some plastic welding strips, to no avail. Could...
Leave a comment:
-
side skirt rivets
Hi all. I'm putting my side skirts back on after doing a repair on one of them....and it's been 6 months. I'm blanking on where the 51118174184 (gray)...
-
I was going to say AS4 plus, but then noticed you’re somewhere warm!!!!
Leave a comment:
-
-
Reattaching side skirts…
Had to replace some clips on the side skirts, and now it’s time to put them back. Are the clips sufficient or should I get some 3M double sided tape...
-
Blast from the past...had these done Dec 2017 at ~170K miles.
Applicable Blackstone report (pre bearing replacement) :
and...
Leave a comment:
-
Been a busy year. Subframe reinforcement, new bushings throughout and engine mounts, new upper control arms, new rear wheel bearings, and finally a new...
- Likes 1
Leave a comment:
-
Could we add links to a valve adjustment DIY?
https://www.youtube.com/watch?v=SoYVubj9y5U
https://m3support.net/thread/13/e46-m3-valve-a...
- Likes 1
Leave a comment:
Leave a comment: